alliance RV paradigm 2021 Battery Disconnect Switch User Manual
Battery Disconnect Switch
Used to shut off all 12‐volt power that supplies RV. When the switch is activated the batteries are disconnected/isolated and no longer supply 12‐volt power to the RV. You will find the battery disconnect switch in the pass thru storage compartment of the 5th wheel and are typically mounted above docking station.
To operate the switch, simply turn the lever to the ON or OFF position. As shown below, a lanyard is attached to prevent the removable lever from being misplaced.
Solar Prep
Alliance RVs are all solar-prepped. The basic solar prep includes a pre‐installed CEP (cable entry plate) mounted on the roof of the RV. The wiring from the CEP will run to a convenient location in the RV in which a solar charge controller can be installed inline.
NOTE:
This will be identified by a label. This label could be in various locations in the RV. If you cannot locate this entry point, please give us a call!
Solar Prep (Continued)
The wiring from the cable entry point will then continue from the pre‐determined controller location to the battery compartment and tie DIRECTLY into the battery. The solar prep is now ready for a solar panel and solar controller. By adding a panel and controller, you will not have a solar charge going directly to your auxiliary battery that will support your 12-volt system. Please contact Alliance RV or your dealer for details on the controller and panel. With the addition of an inverter (we recommend an inverter with a built-in transfer switch) and some additional wiring, the solar power you’ll be receiving can also positively impact your 120-volt system. Consult with your RV dealer for more detail.
NOTE:
Our solar prep and solar option are low voltage systems. For more details or any questions, please contact your Alliance RV dealer or Alliance RV.
Solar Option
Alliance RVs solar option is the complete RV power package. An economical and powerful way to have most of the comforts you need wherever your dry camp. The system features all the components that will allow convenient access to AC or solar power through your breaker panel, and the ability to charge batteries from both shore and solar power. This system is easily expandable into a full‐time system and is lithium battery compatible. For additional details, please contact your Alliance RV dealer or Alliance RV.
Generator Prep (If Equipped)
With Generator Prep, you’ll find that your RV will include the basic wiring and structures needed to install an aftermarket generator. A mounting base, a vapor isolating shroud, an electrical transfer switch, and the associated wiring are in place. We recommend you work with your dealer and/or Alliance RV if you decide to add a generator to your RV.
Generator (If Equipped)
RV generators supply power when you’re away from electrical hookups. These can be permanently installed and are designed to provide power for air conditioners, lighting, and appliances. Alliance RV offers generator prep and full generator options with our 5th wheels.
Generator (Continued)
WARNING
THOROUGHLY READ THE OPERATORS ‘ MANUAL BEFORE OPERATING THE GENERATOR. IT CONTAINS IMPORTANT INSTRUCTIONS THAT SHOULD BE FOLLOWED DURING OPERATION AND MAINTENANCE. SAFE OPERATION AND TOP PERFORMANCE CAN ONLY BE ACHIEVED WHEN EQUIPMENT IS PROPERLY OPERATED AND MAINTAINED.
WARNING
OPERATION OF EQUIPMENT IS UNSAFE WHEN MENTALLY OR PHYSICALLY FATIGUED. DO NOT OPERATE EQUIPMENT IN THIS CONDITION, OR AFTER CONSUMING ANY ALCOHOL OR DRUG.
MAINTAINING OR INSTALLING A GENERATOR SET CAN CAUSE SEVERE PERSONAL INJURY. WEAR PERSONAL PROTECTIVE EQUIPMENT SUCH AS SAFETY GLASSES, PROTECTIVE GLOVES, STEEL‐TOED BOOTS, AND PROTECTIVE CLOTHING WHEN WORKING ON EQUIPMENT.
NEVER OPERATE THE GENERATOR WITH THE COVER OR SERVICE DOOR REMOVED, IT MAY RESULT IN SEVERE PERSONAL INJURY OR EQUIPMENT DAMAGE. STARTING FLUIDS, SUCH AS ETHER, CAN CAUSE EXPLOSION AND GENERATOR SET ENGINE DAMAGE. DO NOT USE.
GENERATOR VOLTAGE IS DEADLY, AN IMPROPERLY CONNECTED GENERATOR ELECTRICAL OUTPUT CONNECTIONS CAN CAUSE EQUIPMENT DAMAGE, SEVERE PERSONAL INJURY, OR DEATH. ELECTRICAL CONNECTIONS MUST BE MADE BY A TRAINED AND EXPERIENCED ELECTRICIAN IN ACCORDANCE WITH APPLICABLE CODES. ENGINE EXHAUST/CARBON MONOXIDE IS DEADLY, SUBSTANCES IN THESE GASES HAVE BEEN IDENTIFIED BY SOME STATE AND FEDERAL AGENCIES TO CAUSE CANCER OR REPRODUCTIVE TOXICITY. DO NOT BREATHE IN OR COME INTO CONTACT WITH EXHAUST GASSES.
Generator (Continued)
Your generator has a nameplate that contains the model and serial numbers. This information will be needed for any service needs.
Key Component Locations
- Control Panel
- Air Filter Cover
- Removable Access Cover
- Oil Drain Valve
- Oil Filter
- Oil Fill Cap and Dipstick
- Fuel Filter
Starting the Generator
- Visually inspect for fuel and/or exhaust leaks. Do NOT start the generator until any fuel or exhaust leak is repaired.
- Position and hold the control switch to START until the generator starts. The status indicator on the switch flashes while cranking. It will stay on continuously when the generator set is running.
Starting the Generator (Continued) - If the generator fails to start, cranking will stop in approximately 30 seconds. The status indicator will blink, indicating an over crank fault. Wait 5 seconds for the control to reset before trying again. After 5 tries, let the starter motor cool down for 30 seconds before trying again.
- For top performance and engine life, especially in colder weather, let the engine warm up for 2 minutes before you put a load on the generator.
Stopping the Generator
- Turn off your air conditioners and any other large appliances.
- Run the generator for 2 minutes to allow for a cool down.
- Press the control switch into the STOP position.
The Load on the Generator
The power rating on the generator nameplate determines how much electrical load (motors, fans, heaters, air conditioners and other appliances) the generator can power. If the sum of the loads exceeds the generator set power rating, the generator will shut down or its line circuit breakers will trip.
To avoid shutdowns due to generator overload, use the electrical ratings from each appliance to compare the sum of the electrical load likely to be used at the same time to the generator rating. Appliance load and generator power are measured in terms of watts or kilowatts. 1 kilowatt = 1000 watts.
Reference Links
View Full User Guide: alliance RV paradigm 2021 User Manual
Download Manuals: https://dev.alliancerv.com/owners-manuals
alliance 2023 Top Accessories
[amalinkspro_table id=”32452″ new-window=”on” nofollow=”on” addtocart=”off” /]