How To Install Pelsee P12 Pro Max Rear View Mirror Camera User Manual
A cutting-edge dash camera for the rearview mirror that is intended to improve convenience and safety while driving is the Pelsee P12 Pro Max. Its four-k UHD front camera and waterproof, 2.5-k back camera provide wide-ranging coverage from in front of the car to behind it. With the help of cutting-edge Wide Dynamic Range (WDR) technology, this configuration guarantees excellent recordings even in changing lighting circumstances.
With its 12-inch IPS touchscreen and anti-glare coating, the camera provides a clear view of recordings under various lighting circumstances. This screen shows the feeds from both the front and rear cameras at the same time, replacing your traditional rearview mirror. The “Pelsee Cam” app is used to link cellphones to the camera, which has built-in WiFi. This program lets you edit, play, and download videos in real-time. It also lets you share them.
The camera uses time-lapse recording to effectively manage power and video storage, allowing it to function as a 24-hour parking monitor. Its usefulness is further increased by features like ADAS (Advanced Driver Assistance System), Blind Spot Detection (BSD), and a G-sensor for impact detection.
What’s In the Box
INSTALLATION OF YOUR DASH CAMERA
Step 1
Insert a memory card (should support up to 256GB and be a class 10 or higher speed card) into the dash camera.
Step 2
Use the rubber straps to mount the dash camera on your original rearview mirror.
Step 3
Connect the Type-C port of the car charger to the dash camera, then plug the Other end of the car charger into the cigarette lighter receptacle in your vehicle.
Step 4
Connect the AV output port of the rear camera kit to the dash camera, then carefully route the cable through the vehicle to its rear section.
Step 5
Set the vehicle in reverse gear, then identify the wire that feeds the Reverse Light from the rear light cluster. Tie the Red Trigger Wire with the positive terminal of the correct wire.
Step 6
Attach the rear camera securely to the back of your vehicle with the 3M adhesive Pad or the screws.
Step 7
Insert the GPS module into the dash camera and attach it in a suitable location with the letters GPS facing upwards.
Different icons on the screen
- GPS module inserted. insufficient satellites found.
- Enough Satellites Searched
Step 8
Start the engine to verify if the installation has been done correctly.
Frequently Asked Questions
The Pelsee P12 Pro Max supports up to a 256GB memory card, class 10 or higher.
Yes, the dash cam starts recording automatically when powered on with a memory card inserted.
This could be due to the built-in battery running low. Charge the dash cam for a few days to resolve this.
The effective Wi-Fi range is about 10 ft from the dash cam.
This could be due to an issue with the car cigarette power outlet or the car charger.
No, the dash cam supports Loop Recording, which overwrites old recordings with new ones.
A hardwire kit is needed. The dash cam records in time-lapse throughout the night when the parking mode is on.
These are software applications to assist drivers, but should not be solely relied upon for safety.
The dash cam is designed as a rearview mirror with a recording function. It’s recommended to turn off the screen during driving to avoid glare.
No, they operate separately with the front and rear cameras.
Connect the red wire of the rear camera cable to the positive pole of the reverse light.
Adjust the physical position of the rear camera by unscrewing and repositioning it.