How To Install Pyle PLCMDVR49 Dash Cam Rearview Mirror User Manual
PLCMDVR49 DVR Rearview Mirror Dash Cam Kit is developed to find evidence in case of a traffic accident. This camera can also be used on other occasions such as[ meetings, monitoring and forensics, location shooting, and video evidence. This product is a blend of wide dynamic digital industry-leading cameras, with no leakage of seconds, seamless circular camera, ultra wide angle shooting, with display real-time playback, mobile detection camera, and parking guard technology in one; streamlining the design of unique fashion, favored by a vast number of consumers.
This manual will detail how to install, and operate the product parameters and matters needing attention. Please read it carefully and keep it for future reference before use. The specification parameters may be due to upgrades, updates, and other reasons to change, refer to the actual product, without prior notice. The manufacturer reserves without prior notice, to change the technology of direct rights.
INSTALLATION NOTES
This product should be tied together with the original rear-view mirror, To determine whether the lens in the windshield wiper range, ensures good vision, also good even in rainy environments.
Don’t touch the lens with your fingers, the finger’s grease may remain in the lens, resulting in the camera or photograph being unclear, please clean the lens regularly.
Recorder Installation
- Insert Memory Card: Insert the Micro SD card by following the device memory card instructions, DVR supports memory sizes from 4GB to 32G (Class 6 Above).
Note
Please format the memory card before using the machine for the first time. - Removing the memory card in the memory card slot: Turn off the camera first then press pop-up.
Note
If the camera is powered on, do not remove or insert the memory card. - Installing on the rear-view mirror
The equipment will be installed with the silica gel, the left position of the lens from the original car rear-view mirror, equipment flat on the original car rear-view mirror, and strained silicon adhesive tape, hanging below the hook. The equipment will be fastened in the original car rear-view mirror. - Connect the power supply
Please use the original charger, and connect one end of the charger to the USB interface of the camera, then insert the other end of the car charger into the car cigarette port. - Turn On / Off Device
The automatic on / off: Automatically boots the device when the auto engine starts. The DVR will record automatically when your car’s engine starts. If the car charger is constantly plugged in, the DVR will stop recording and save the data to your micro SD card automatically. There 15-second delay when your car’s engine is off, then the DVR turns off.
The manual on/off: Short Press ” ” Power ON/OFF button, and you will hear a “music” sound, The DVR will start to record automatically, To stop recording press the “OK” Rec/Confirm Button, and the DVR will save the data to your SD card and be in standby mode. Short Press “the” Power ON/OFF button again to turn off the camera.
Frequently Asked Questions
Dual Camera System, Full HD 1080p front dash cam, waterproof rearview backup cam, DVR recording, 4.3” digital display screen, instant playback, and built-in rechargeable battery.
The device attaches to your existing rearview mirror using silicon adhesive tape.
It includes the DVR Mirror Assembly, Backup Camera, Car Power Cable, and USB Transfer Cable.
The front camera has a 120° view angle and the back camera 90°. The video resolution is 1080P (1920×1080) for the front and 640 x 480 30fps for the back.
It features loop recording with 1, 2, or 3-minute intervals and a G-Sensor that auto-saves video during collisions.
It includes a vehicle cigarette lighter power accessory cable and a built-in rechargeable 450mAh battery.
The device supports Micro SD cards up to 32 GB (not included).
It measures 12.0” x 1.6” x 3.3” inches and weighs approximately 0.53 lbs.
Yes, it starts recording for 10-15 seconds when external vibrations are detected while the car’s engine is off.
Yes, it records for 10-30 seconds when movement is detected within 3 meters.
Yes, during recording, you can press a key to lock important files so they won’t be overwritten.
The USB mode can be selected for charging the device.
In standby mode, enter the menu settings to adjust the date and time.
Yes, the device allows for instant playback and preview of recorded media.