2019 Honda Insight Indicators | How To use

• Comes on when the parking brake is applied and goes off when it is released.
• Comes on when the brake fluid level is low.
• Comes on if there is a problem with the brake system.
• The beeper sounds and the indicator comes on if you drive with the parking brake not fully released.
• Comes on for about 30 seconds when you pull or push the electric parking brake switch when the power mode is in ACCESSORY or VEHICLE OFF.

• Stays on for about 30 seconds when you set the power mode to VEHICLE OFF while the electric parking brake is set.

• Comes on while driving – Make sure the parking brake is released. Check the brake fluid level.

What to do when the indicator comes on while driving

• Comes on along with the brake system indicator (amber) -Immediately stop in a safe place. Contact a dealer for repair. The brake pedal becomes harder to operate. Depress the pedal further than you normally do.
• Comes on along with the ABS indicator – Have your vehicle checked by a dealer.

If the Brake System Indicator (Red) Comes On or Blinks

• Blinks and the brake system indicator (amber) come on at the same time – There is a problem with the electric parking brake system. The parking brake may not be set.

Avoid using the parking brake and have your vehicle checked by a dealer immediately.

If the Brake System Indicator (Red) Comes On or Blinks at the Same Time When the Brake System Indicator (Amber) Comes On

• Comes on if there is a problem with a system related to braking other than the conventional brake system.
• Comes on if there is a problem with the cooperative control with regenerative braking, the electric servo brake system, or the hill start assist system.
• Comes on if there is a problem with the electric parking brake system.

• Stays on constantly – Avoid high speeds and sudden braking. Take the vehicle to a dealer immediately.
• Comes on while driving – Avoid using the parking brake and have your vehicle checked by a dealer immediately.

• Comes on if there is a problem with

• Comes on when the automatic brake hold system is on.

• Comes on when the automatic brake hold is activated.

Indicator

• Comes on if there is a problem with the electric vehicle system.
• Comes on when the High Voltage battery temperature becomes high.

• Have your vehicle checked by a dealer.

Indicator

• Comes on when the vehicle is ready to drive.

• Comes on when the vehicle is moved by the motor, and the engine is not operating.

• Comes on when the vehicle is in EV mode.

• After you have set the power mode to ON, the vehicle performs system checks. However, if the readiness codes have not been set by that time, this indicator will blink five times and then go off.
• Comes on if there is a problem with the emissions control system.
• Blinks when a misfire in the engine’s cylinders is detected.
• Comes on if the fuel fill cap is loose or missing.

• Readiness codes are part of the onboard diagnostics for the emissions control systems.

Testing of Readiness Codes

Comes on while driving – Have your vehicle checked by a dealer.

Blinks while driving – Stop in a safe place where there are no flammable objects. Stop the power system for 10 minutes or more, and wait for it to cool down. Then, take your vehicle to a dealer.

If the Malfunction Indicator Lamp

Comes On or Blinks 

• Comes on – Check the fuel cap before taking your vehicle to a dealer.

• Comes on when the 12-volt battery is not charging.

• Comes on while driving – Turn off the climate control system and rear defogger to reduce electricity consumption.

If the 12-volt Battery Charging System Indicator Comes On 

• Indicates the current shift position.

• Comes on when the paddle selector is pulled.
• Blinks when deceleration does not occur while pulling the paddle selector.
• Comes on with M when SPORT mode is selected and pulls the paddle selector.

• The current shift position blinks if the transmission system has a problem.

• Blinks while driving – Avoid sudden starts and acceleration and have your vehicle checked by a dealer immediately.

• The current shift position or all the shift positions blink if there is a problem with the transmission and the vehicle is no longer able to run.

• Immediately park your car in a safe place.

Emergency Towing

• Have your vehicle checked by a dealer.

• The current shift position or all the shift positions blink if there is a problem with the transmission and it is not possible to select (P.

• While the vehicle is stopped, apply the parking brake.
• Have your vehicle checked by a dealer immediately.

• Blinks and the beeper sounds for a few seconds if you are not wearing a seat belt when you set the power mode to ON, then the indicator comes on.
• If the front passenger is not wearing a seat belt, the indicator comes on a few seconds later.
• Blinks while driving if either you and/or the front passenger has not fastened a seat belt. The beeper sounds and the indicator blinks at regular intervals.

• The beeper stops and the indicator goes off when you and the front passenger fasten their seat belts.
• Stays on after you and/or the front passenger have fastened the seat belt(s) – A detection error may have occurred in the sensor. Have your vehicle checked by a dealer.

Seat Belt Reminder

• Comes on when the fuel reserve is running low (approximately 1.59

U.S. gal./6.0 Liter left).

• Blinks if there is a problem with the fuel gauge.

• Comes on – Refuel your vehicle as soon as possible.
• Blinks – Have your vehicle checked by a dealer.

•  Comes on if there is a problem with the ABS.

• Stays on constantly – Have your vehicle checked by a dealer. With this indicator on, your vehicle still has normal braking ability but no anti-lock function.

Anti-lock Brake System (ABS)

• Comes on if a problem with any of the following is detected:

–  Supplemental restraint system

–  Side airbag system

–  Side curtain airbag system

–  Seat belt tensioner

• Stays on constantly – Have your vehicle checked by a dealer.

• Comes on if there is a problem with the EPS system.

• Stays on constantly – Have your vehicle checked by a dealer.

If the Electric Power Steering (EPS) System Indicator Comes On

• Blinks when VSA® is active.
• Comes on if there is a problem with the VSA® system.

• Stays on constantly – Have your vehicle checked by a dealer.

Vehicle Stability Assist® (VSA®), aka Electronic Stability Control (ESC), System

• Comes on if the VSA® system is deactivated temporarily after the 12-volt battery has been disconnected, and then re-connected.

• Drive a short distance at more than 12 mph (20 km/h). The indicator should go off. If it does not, have your vehicle checked by a dealer.

• Comes on when you partially disable VSA®.

• Comes on if the VSA® system is deactivated temporarily after the 12-volt battery has been disconnected, and then re-connected.

• Drive a short distance at more than 12 mph (20 km/h). The indicator should go off. If it does not, have your vehicle checked by a dealer.

• May come on briefly if the power mode is set to ON and the vehicle is not moved within 45 seconds, to indicate the calibration process is not yet complete.
• Comes on and stays on when:

–  One or more tires’ pressures are determined to be significantly low.

–   The system has not been calibrated.

• Comes on while driving – Stop in a safe place, check tire pressures, and inflate the tire(s) if necessary.
• Stays on after the tires are inflated to the recommended pressures – The system needs to be calibrated.

TPMS Calibration

• Blinks for about one minute, and then stays on if there is a problem with the TPMS, or when a compact spare tire* is temporarily installed.

• Blinks and remains on – Have your vehicle checked by a dealer. If the vehicle is fitted with a compact spare tire, get your regular tire repaired or replaced and put it back on your vehicle as soon as you can.

• Comes on if the TPMS is deactivated temporarily after the 12-volt battery has been disconnected, and then re-connected.

• Drive a short distance at more than 12 mph (20 km/h). The indicator should go off. If it does not, have your vehicle checked by a dealer.

• Blinks when you operate the turn signal lever.
• Blink along with all turn signals when you press the hazard warning button.

• Does not blink or blink rapidly

Replacing Light Bulbs

• Comes on when the high-beam headlights are on.

• Comes on when the light switch is in a position other than OFF or when the switch is set to AUTO and the exterior lights come on.

• If you set the power mode to VEHICLE OFF while the lights are on, a chime sounds when the driver’s door is opened.

• Comes on when the fog lights are on.

• Comes on when all the operating conditions of the auto high-beam are met.

• Blinks if the immobilizer system cannot recognize the key information.

• Blinks – You cannot start the power system. Set the power mode to VEHICLE OFF*1, then select the ON mode again.
• Repeatedly blinks – The system may be malfunctioning. Have your vehicle checked by a dealer.
• Do not attempt to alter this system or add other devices to it. Electrical problems can occur.

• Blinks when the security system alarm has been set.

• Comes on along with a beep when a problem is detected. A system message on the driver information interface appears at the same time.

• While the indicator is on, press the  (home) button to see the message again.

Accessing contents in the main display

• Refer to the Indicator information in this chapter when a system message appears on the driver information interface. Take the appropriate action for the message.
• The driver information interface does not return to the normal screen unless the warning is canceled, or the left selector wheel is pressed.

• Comes on when the ECON mode is on.

• Comes on when you press the

SPORT button.

• The ambient meter remains lit up in red as long as SPORT mode is on.

• Comes on if there is a problem with ACC with Low-Speed Follow.

• Stays on constantly – Have your vehicle checked by a dealer.

• Indicators may come on temporarily when the Maximum Load Limit is exceeded.
• ACC with Low-Speed Follow has been automatically canceled.

•  Make sure the total load is within the Maximum Load Limit.

Maximum Load Limit 

• Stays on constantly – Have your vehicle checked by a dealer.

• Comes on if the ACC with Low-Speed Follow is deactivated temporarily after the 12-volt battery has been disconnected, and then re-connected.

• Drive a short distance at more than 12 mph (20 km/h). The indicator should go off. If it does not, have your vehicle checked by a dealer.

• Comes on when you press the

MAIN button.

• Comes on if there is a problem with the LKAS.

• Stays on constantly – Have your vehicle checked by a dealer.

• Comes on when you press the

MAIN button.

• Comes on if there is a problem with RDM or CMBSTM.

• Stays on constantly – Have your vehicle checked by a dealer.

• Indicators may come on temporarily when the Maximum Load Limit is exceeded.

• Make sure the total load is within the Maximum Load Limit.

Maximum Load Limit

• Stays on constantly – Have your vehicle checked by a dealer.

• Comes on if the RDM and CMBSTM are deactivated temporarily after the 12-volt battery has been disconnected and then re-connected.

• Drive a short distance at more than 12 mph (20 km/h). The indicator should go off. If it does not, have your vehicle checked by a dealer.

• Comes on when RDM and/or CMBSTM shuts itself off.

• The indicator may come on temporarily when passing through an enclosed space, such as a tunnel.
• The area around the radar sensor is blocked by dirt, mud, etc. Stop your vehicle in a safe place and wipe the debris off with a soft cloth.
• Have your vehicle checked by a dealer if the indicator does not go off even after you have cleaned the radar sensor.

Collision Mitigation Braking SystemTM (CMBSTM)

• Stays on – The temperature inside the camera is too high.

Use the climate control system to cool down the camera.

The system activates when the temperature inside the camera cools down.

Front Sensor Camera

• Comes on when RDM and/or CMBSTM shuts itself off.

• Stays on – The area around the camera is blocked by dirt, mud, etc. Stop your vehicle in a safe place and wipe the debris off with a soft cloth.
• Have your vehicle checked by a dealer if the indicator and message are still displayed even after you have cleaned the area around the camera.

Front Sensor Camera

• Lights up in green when RDM and CMBSTM are on.
• Lights up in green and gray when RDM or CMBSTM are off.
• Lights up in gray when RDM and CMBSTM are off.

CMBSTM On and Off