2022 Honda Insight Wipers
Introduction
The 2022 Honda Insight has highly effective and cutting-edge wiper technologies to provide the best visibility and safety under all weather conditions. In order to give drivers a clean line of sight and reduce distractions, these wipers are made to efficiently clear the windshield and rear glass. The wipers on the 2022 Honda Insight contribute to a better driving experience by automatically altering their speed dependent on the intensity of the rainfall thanks to features like changeable intermittent settings and rain-sensing technology. This considerate addition exemplifies Honda’s dedication to incorporate cutting-edge technologies to enhance the general driving experience and safety of its vehicles.
Wipers and Washers
Windshield Wipers/Washers
The windshield wipers and washers can be used when the power mode is in ON.
- MIST
The wipers run at high speed until you release the lever. - Wiper Switch (OFF, INT*1/AUTO*2, LO, HI)
Move the lever up or down to change the wiper settings. - Adjusting Wiper Operation
Turn the adjustment ring to adjust the wiper operation.
Lower speed, fewer sweeps
Higher speed, more sweeps
Washer
- Sprays while you pull the lever toward you.
- When you release the lever for more than one second, the spray stops, the wipers sweep two or three more times to clear the windshield, then stop.
- Models with manual intermittent operation
- Models with automatic intermittent operation
Not available on all models
Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry. The windshield will get scratched, or the rubber blades will get damaged.
NOTICE
- Turn the washers off if no washer fluid comes out. The pump may get damaged.
- The wiper motor may stop motor operation temporarily to prevent an overload. Wiper operation will return to normal within a few minutes, once the circuit has returned to normal.
Models With Intermittent Time Adjustment Ring
- If the vehicle speeds up while the wipers are operating intermittently, the length of the wipe interval shortens.
- When the vehicle speeds up, the wiper operation’s shortest delay setting
and the 
setting become the same.
NOTICE
- In cold weather, the blades may freeze to the windshield.
- Operating the wipers in this condition may damage the wipers. Use the defogger to warm the windshield, then turn the wipers on.
Automatic Intermittent Wipers
- When you push the lever down to AUTO, the windshield wipers sweep once, and go into the automatic mode.
- The wipers operate intermittently, at low speed, or at high speed and stop in accordance with the amount of rainfall the rainfall sensor detects.
AUTO Sensitivity Adjustment
When the wiper function is set to AUTO, you can adjust the sensitivity of the rainfall sensor (using the adjustment ring) so that wipers will operate in accordance with your preference.
Sensor Sensitivity
Low Sensitivity
High Sensitivity
Wipers and Washers
- If the wipers stop operating due to an obstacle such as the buildup of snow, park the vehicle in a safe place.
- Rotate the wiper switch to OFF, and set the power mode to ACCESSORY or VEHICLE OFF (LOCK), then remove the obstacle.
Automatic Intermittent Wipers
The rainfall sensor is in the location shown below.
NOTICE
AUTO should always be turned OFF before the following situations in order to prevent severe damage to the wiper system:
- Cleaning the windshield
- Driving through a car wash
- No rain present
Wipers and Washers
Wiper/Washer Control Lever
Adjustment Ring
-
- Low Sensitivity*1
Lower speed, fewer sweeps*2
- AUTO: Wiper speed varies automatically
INT: Low speed with intermittent - LO: Low speed wipe
- HI: High speed wipe
- Models with automatic intermittent wipers
- Models without automatic intermittent wipers
FAQs
Use the wiper stalk on the right side of the steering column to control the wipers. To alter the delay settings, use the intermittent settings and push it up or down to wipe once or repeatedly.
Wiper blades that aren’t clean or a filthy windshield can both result in streaking. Regularly clean the windscreen and the blades. Replace the wiper blades if streaking continues.
The front windshield of the 2022 Honda Insight often has wiper blades that are 26 inches long, while the rear window typically has wiper blades that are 14 or 16 inches wide.
Every six to twelve months, or as soon as you observe diminished wiping performance or obvious damage, the wiper blades should be replaced.
As long as they are the right size and kind for your Insight model, you can use aftermarket wiper blades. Make careful you abide by the manufacturer’s instructions.
Press the tiny tab or button on the underside of the wiper blade to release it from the wiper arm by lifting the wiper arm away from the windshield. Once it clicks, move the new blade into position.
Yes, in order to prevent potential harm to the wiper motor or blades, it is a recommended practice to switch off the wipers before turning off the car.
Yes, you can clean the back window with windshield wiper fluid. Simply check the fluid to make sure it doesn’t include any components that could damage the rear glass or the rear wipers.
If only the rear wiper is malfunctioning, there may be a problem with the wiper arm, the fuse, or the rear wiper motor. If the problem persists after checking the fuse, think about calling a mechanic.
Although the wipers can function in light icy conditions, it is preferable to remove any ice buildup from the windshield before operating the wipers to avoid harming the blades or motor.
Utilize the wiper stalk located on the steering column’s right side. Different sensitivity settings or the length of time between wipes are frequently used to signify the delay settings.
Not necessarily. Frequently, replacing the wiper blades or other minor components can fix problems. However, you might need to repair the wiper assembly if it is broken.
Avoid operating the wipers on a dry windshield, keep the glass and wiper blades clean, and gently wipe the blades with a soft cloth and windshield wiper fluid on occasion.
It’s probably time to change the wiper blades if you notice any skipping, streaking, smearing, or decreased visibility while driving in the rain.
If you’re not comfortable changing the wiper blades yourself, the majority of dealerships and mechanics do offer replacement services. Use only high-quality blades that are suitable with your Insight model.
Useful Links
View full PDF: 2022 Honda Insight |Auto User Guide