• Appears when the fuel fill cap is loose or is not installed.

• Appears when the scheduled maintenance is due soon.

Consequently, Maintenance Due Now and Maintenance Past Due follow.

• Appears when the washer fluid is low.

• Refill the washer fluid.

Refilling Window Washer Fluid4

• Appears while you are customizing the settings and the shift lever is moved out of (P.

• Appears if the automatic brake hold is automatically canceled while it is in operation.

• Immediately depress the brake pedal.

• Appears when the automatic brake hold system is turned off.

• Appears when the automatic brake hold button is pressed without wearing the driver’s seat belt.

• Fasten the driver’s seat belt.
  Automatic Brake Hold 

• Appears when the automatic brake hold button is pressed without depressing the brake pedal while the automatic brake hold is in operation.

• Press the automatic brake hold button with the brake pedal depressed.

Automatic Brake Hold 

• Appears when the parking brake is applied automatically while it is in operation.

• Appears when the electric parking brake switch is pressed without depressing the brake pedal while the electric parking brake is in operation.

• Press the electric parking brake switch with the brake pedal depressed.

Parking Brake 

• Appears when the ignition key is turned to ACCESSORY (q from ON (w. (The driver’s door is closed.)

• Appears when you open the driver’s door while the ignition key is in ACCESSORY (q.

• Turn the ignition switch to LOCK (0, then remove the key.

• Appears when you open the driver’s door while the ignition key is in LOCK (0.

• Remove the key from the ignition switch.

• Appears after you unlock and open the driver’s door.

• Appears when the steering wheel is locked.

• Move the steering wheel left and right while pressing the ENGINE START/STOP button.

• Appears if you push the ENGINE START/STOP button to turn the engine off without the shift lever in (P.

• Move the shift lever to (P. The power mode changes to VEHICLE OFF.

• Appears when the power mode is in ACCESSORY.

• Appears after the driver’s door is opened when the power mode is in ACCESSORY.

• Press the ENGINE START/STOP button twice with your foot off the brake pedal, to change the power mode to VEHICLE OFF (LOCK).

• Appears when you close the door with the power mode in ON without the smart entry remote inside the vehicle.

• Goes off when you bring the smart entry remote back inside the vehicle and close the door.

Smart Entry Remote Reminder 

• Appears when the smart entry remote battery becomes weak.

• Replace the battery as soon as possible.

Replacing the Button Battery 

• Appears if the smart entry remote battery is too weak to start the engine or the key is not within operating range to start the engine. A beeper sounds six times.

• Bring the smart entry remote in front of the ENGINE START/STOP button to be touched with.

If the Smart Entry Remote Battery is Weak 

• Appears when there is a problem with the sensor on the battery.
• Appears when the battery is not charging.

• Have your vehicle checked by a dealer.

Checking the Battery 

• Appears along with the battery charging system indicator – Turn off the climate control system and rear defogger to reduce electricity consumption.

If the Charging System Indicator Comes On 

• Appears when the starter system has a problem.

• As a temporary measure, press and hold the ENGINE START/STOP button for up to 15 seconds while pressing the brake pedal, and manually start the engine.

Have your vehicle checked by a dealer.

• Appears for about three seconds when ACC has been automatically canceled.

• You can resume the set speed after the condition that caused ACC to cancel improves. Press the RES/+ button.

Adaptive Cruise Control (ACC) 

• Flashes when the system senses a likely collision with a vehicle in front of you.

• Take appropriate action to prevent a collision (apply the brakes, change lanes, etc.).

Adaptive Cruise Control (ACC) 

Collision Mitigation Braking SystemTM (CMBSTM)

• Appears when the LKAS is in operation, or the LKAS button is pressed, but there is a problem with a system related to the LKAS. The LKAS cancels automatically. The beeper sounds simultaneously.

• If any other system indicators come on, such as the VSA®, ABS and brake system, take appropriate action.

Indicators

• Appears when the camera has been cooled down and LKAS is available.

• Pressing the MAIN/LKAS button can resume the system.

Front Sensor Camera 

• Appears if there is a problem with the auto high- beam.

• Manually operate the headlight switch.
• If you are driving with the high beam headlights when this happens, the headlights are changed to low beams.

• Appears if anything covers the radar sensor cover and prevents the sensor from detecting a vehicle in front.
• May appear when driving in bad weather (rain, snow, fog, etc.)

• When the radar sensor gets dirty, stop your vehicle in a safe place, and wipe off dirt using a soft cloth.
• Have your vehicle checked by a dealer if the message does not disappear even after you clean the sensor cover.

Radar Sensor 

Honda Sensing®*

• Appears if the temperature inside the front sensor camera is too high and some driver assist systems cannot be activated.

• Use the climate control system to cool down the camera.
• Disappears – The camera has been cooled down and the systems are activated normally.

Front Sensor Camera
Honda Sensing®* 

• Appears if the area around the front sensor camera is blocked by dirt, mud, etc. and be prevented from detecting a vehicle in front.
• May appear when driving in bad weather (rain, snow, fog, etc.)

• When the front window gets dirty, stop your vehicle in a safe place, and wipe it off with a soft cloth.
• Have your vehicle checked by a dealer if the message does not disappear even after you cleaned the area around the camera.

Front Sensor Camera 

Honda Sensing®* 

• Appears when the vehicle is driving out of a detected line. The steering wheel vibrates rapidly.

• Keep the vehicle within the lane you are driving.

Lane Keeping Assist System (LKAS) 

• Appears when the vehicle is driving out of a detected line.

When you selected Warning Only The steering wheel vibrates rapidly when the vehicle is drifting out of a detected line.

When you selected Narrow, Normal or Wide

The steering wheel vibrates rapidly when the vehicle is drifting out of a detected line. The system also steers the vehicle to help you remain within your driving lane.

• Keep the vehicle within the lane you are driving.

Road Departure Mitigation (RDM) System 

• You can change the setting for the road departure mitigation system. Narrow, Normal, Wide, and Warning Only can be selected.

Customized Features 

When you selected Narrow

• Appears when the vehicle is likely to drive out of a detected line.
  • The system steers the vehicle to help you remain within your driving lane.

—

• Blinks when you fail to steer the vehicle. The beeper sounds simultaneously.

• Operate the steering wheel to resume the LKAS.

• Appears if the temperature inside the camera is too high.
• The LKAS has been automatically canceled.

• Use the climate control system to cool down the camera.
• Goes off – The camera has been cooled down. Pressing the LKAS button can resume the system.

Front Sensor Camera
Lane Keeping Assist System (LKAS) 

• Appears if not wearing a seat belt when you set the power mode to ON.

• Goes off after you or the front passenger or both of you have fastened your seat belts.

• Appears if there is a problem with the fuel gauge.

• Blinks – Have your vehicle checked by a dealer.

• Appears when the fuel reserve is running low (approximately 1.98 U.S. gal./7.5 Liter left).

• Appears – Refuel your vehicle as soon as possible.

Fuel Gauge 

•  Appears if any door is not completely closed.
• The beeper sounds and the message appears on if any door or the tailgate is opened while driving.

• Goes off when all doors are closed.

• Appears if the tailgate is not completely closed.

• Goes off when the tailgate is closed.

• Appears if any door or the tailgate is not completely closed.

• Goes off when all doors and the tailgate are closed.

• Appears when ECON mode is turned off by pressing ECON button.

2 ECON Button

•  Appears when approaching a intersection during route guidance.

• Appears when set the power mode to ON while driving.

• Appears if there is a problem with the automatic lighting control system.

• Appears while driving – Manually turn the lights on, and have your vehicle checked by a dealer.

• Appears if there is a problem with the headlights.

• Appears while driving – The headlights may not be on. When conditions allow you to drive safety, have your vehicle checked by a dealer as soon as possible.