• Comes on when you turn the ignition switch to ON  (w*1, and goes off when the engine starts.
• Comes on if there is a problem with the EPS system.

• Stays on constantly or does not come on at all – Have your vehicle checked by a dealer.

2 If the Electric Power Steering (EPS) System Indicator Comes On P. 605

U.S.

models only

Low Tire Pressure/TPMS Indicator

• Comes on for a few seconds when you turn the ignition switch to ON (w*1, then goes off.
• May come on briefly if the ignition switch is turned to ON  (w*1  and the vehicle is not moved within 45 seconds, to indicate the calibration process is not yet complete.
•  Comes on and stays on when:

–  One or more tires’ pressures are determined to be significantly low.

–  The system has not been calibrated.

• Comes on while driving – Stop in a safe place, check tire pressures, and  inflate the tire(s) if necessary.
• Stays on after the tires are inflated to the recommended pressures – The system needs to be calibrated.

2 TPMS Calibration P. 460

•  Blinks for about one minute, and then stays on if there is a problem with the TPMS, or when  a compact spare tire is temporarily installed.

• Blinks and remains on – Have your vehicle checked by a dealer. If the vehicle is fitted with a compact spare, get your regular tire repaired or replaced and put back on your vehicle as soon as you can.

Keyless Access System Indicator*

• Comes on for a few seconds when you set the power mode to ON, then goes off.
• Comes on as soon as a problem is detected in the keyless access system or push button starting system.

• Stays on constantly or does not come on at all – Have your vehicle checked by a dealer.

System Message Indicator*

• Comes on for a few seconds when you turn the ignition switch to ON (w*1, then goes off.
• Comes on along with a beep when a problem is detected. A system message on the multi- information display appears at the same time.

• While the indicator is on, press the (information) button to see the

message again.

• Refer to the Indicators information in this chapter when a system message appears on the multi-information display. Take the appropriate action for the message.
•  The multi-information display does not return to the normal screen unless the warning is canceled, or the

button is pressed.

• Blinks when you operate the turn signal lever.
• Blink if you press the hazard warning button.

• Does not blink or blinks rapidly  –  A turn signal light bulb has blown. Change the bulb immediately.

2 Replacing Light Bulbs P. 547, 550, 551

• Comes on when the high beam headlights are on.

—

Lights On Indicator

• Comes on whenever the light switch is on, or in AUTO* when the exterior lights are on.

Comes on when the fog lights are on.

—

—

Immobilizer System Indicator

•    Comes on if the immobilizer system cannot recognize the key information.

Models without keyless access system

You cannot start the engine. Turn the ignition switch to LOCK  (0, pull the key out, and then insert the key and turn it to ON  (w again.

Models with keyless access system

You cannot start the engine. Set the power mode to VEHICLE OFF (LOCK), then select the ON mode again.

•    Repeatedly blinks – The system may be malfunctioning. Have your vehicle checked by a dealer.

•    Do not attempt to alter this system or add other devices to it. Electrical problems  can occur.

—

Indicator

Indicator

ECON Mode Indicator

• Comes on for a few seconds when you turn the ignition switch to ON (w*1, then goes off.
•  Comes on when you press the ECON button.

2 ECON Button P. 450

Security System Alarm Indicator

• Blinks when the security system alarm has been set.

2 Security System Alarm P. 163

Indicator*

• Comes on when you press the

CRUISE button.

2 Cruise Control* P. 451

Indicator*

•  Comes on if you have set a speed for cruise control.

2 Cruise Control* P. 451

• Comes on when the scheduled maintenance is due soon.

2 Maintenance MinderTM P. 525

All-Wheel Drive (AWD) System Indicator*

•    Comes on if there is a problem with the AWD.

•    Blinks when the AWD system is overheated. The system is inactive.

•    Blinks while driving – the engine drives only the front wheels in this state. Stop in a safe place, shift to  (P, and idle the engine until the indicator goes off. If the indicator does not stop blinking, take your vehicle to a dealer.

2 Real Time AWD with Intelligent Control SystemTM* P. 458

Road Departure Mitigation (RDM)

Indicator*

•    Comes on if there is a problem with the RDM system.

Use the climate control system to cool down the camera.

The system activates when the temperature inside the camera cools down.

2 Front Sensor Camera P. 504

•    Have your vehicle checked by a dealer if the indicator and message come back on after you cleaned the area around the camera.

2 Front Sensor Camera P. 504

•    May come on when driving in bad weather (rain, snow, fog, etc.)

•    Have your vehicle checked by a dealer if the indicator does not go off even after you clean the sensor cover.

2 Radar Sensor P. 506

Collision Mitigation Braking System TM (CMBSTM)

Indicator*

•  Comes on for a few seconds when you turn the ignition switch to ON (w*1, then goes off.

• Comes on when you deactivate the CMBSTM. A multi-information display message appears for five seconds.
• Comes on if there is a problem with the CMBSTM.

• Stays on constantly without the CMBSTM off – Have your vehicle checked by a dealer.

2 Collision Mitigation Braking System TM (CMBSTM) P. 467