Jayco Alante 2023 LP Gas Grill Hookup User Manual

Jayco Alante 2023 LP Gas Grill Hookup User Manual

LP Gas Grill Hookup

Warning

• Be sure to read, understand and follow all information supplied with your recreation vehicle concerning the use of propane before operating the BBQ grill. The propane hose must be correctly connected before lighting the grill. Failure to follow instructions supplied by the grill manufacturer, or use of any components other than those originally supplied with the grill, could result in death or serious injury.
• If you smell gas: Shut off the gas to the appliance, extinguish any open flame, and open the lid. If the odor continues, immediately call your gas supplier or your fire department.
• The BBQ grill is intended for use outside of the recreational vehicle. Never use a gas grill inside a compartment or inside of the recreational vehicle.
• The BBQ grill must be COMPLETELY COOLED before storing. Storing the BBQ grill before it is completely cool may result in serious injury or property damage.

Danger
Always open the grill lid before turning on the gas and lighting burner, failure to open the lid before lighting could cause an explosion causing property damage, injury, or even death.

NOTE:
The outdoor cooking warning labels should not be removed from the RV.

Gas BBQ Grill Prep

Your recreation vehicle is equipped with a propane “quick-coupler” connection for easy installation of the BBQ grill.

Attaching the “Quick Coupler” Connection

The “quick coupler” is directly connected to the RV propane system.
The “quick-coupler” connection is equipped with a positive shut-off valve.
Place the “quick coupler handle in the OFF position and push back the sleeve. The valve handle must be OFF to make the connection.

1. Insert the plug and release the sleeve.
2. Push the plug until the sleeve snaps forward, locking the plug into the socket.
3. Turn the handle ON to allow propane to flow to the drop-in stove.

Range Hood

Warning
Whenever the stove in the RV is being used, the range hood MUST be turned on, and the inner flap MUST be unsnapped and free to move. Failure to do so can create an asphyxiation hazard by restricting airflow through this vent.

Your recreational vehicle is equipped with a range hood, it will be connected to an exterior vent. The vent has an inner flap with two snaps. This flap can be snapped shut when the vehicle is in motion, or during storage to keep insects, debris, snow, rain, etc. from entering the recreational vehicle.
Anytime the stove inside the recreational vehicle is being used, this flap MUST be unsnapped and the range hood turned ON to vent fumes outside the vehicle.

Refrigerator

The refrigerator is not intended for quick freezing or cooling. We recommend stocking it with pre-frozen or pre-cooled food when possible. The shelves should not be covered with paper or plastic and the food items should be arranged so air can circulate freely. Keep the area at the back of the refrigerator clean and free of debris. Check for obstructions in the exterior refrigerator vent area (i.e., spider webs, bird nests, etc.). Use a soft cloth to dust off the debris. For optimum efficiency and performance, it is recommended the refrigerator be checked at least twice a year as part of routine maintenance. For detailed operating and safety information, refer to the manufacturer’s user guide.

Gas/Electric Models (if so equipped)

Warning
If you smell propane gas STOP! Follow the directions located in your manufacturer’s owner’s manual and in this manual.

Residential Models (if so equipped)

NOTE:
If you are using electricity to power the refrigerator, make sure you are connected to a 120-volt power source.

Caution
The ice maker should be turned off and the ice tray emptied when power to your motor home has been shut off. With no power, the ice will melt and water will “pool” in the refrigerator door. When power is restored, the vibration will cause this water to run out of the door and onto the motor home floor.

Cleaning Your Refrigerator

The following are general cleaning guidelines. For detailed information on cleaning your specific refrigerator, refer to the manufacturer’s user guide.

Cleaning the Interior

1. Unplug the refrigerator or disconnect the power.
2. Hand wash, rinse, and dry removable parts and interior surfaces thoroughly. Use a clean sponge or soft cloth and mild detergent in warm water.
3. Inside the refrigerator, use a warm water and baking soda solution consisting of approximately 1 tablespoon (15ml) of baking soda to 1 quart (1 liter) of water. This solution cleans and neutralizes odors. Rinse and wipe dry.
4. Leave an open box of baking soda in the refrigerator and freezer to help prevent odors.

 NOTE:
Do not use abrasive or harsh cleaners such as window sprays, scouring cleansers, flammable fluids, cleaning waxes, concentrated detergents, bleaches, or cleansers containing petroleum products on plastic parts, interior and door liners, or gaskets. Do not use paper towels, scouring pads, or other harsh cleaning tools.

There is no need for routine condenser cleaning in normal operating environments. If the environment is particularly greasy or dusty, or if there is significant pet traffic, the condenser should be cleaned every 2 to 3 months to ensure maximum efficiency.

If you need to clean the condenser:

• Remove the base grille.
• Use a vacuum cleaner with a soft brush to clean the grille, the open areas behind the grille, and the front surface area of the condenser.
• Replace the base grille when finished.

Cleaning the Exterior

Painted metal exteriors: wash with a clean sponge or soft cloth and mild detergent in warm water.

Stainless steel exteriors: wash with a clean sponge or soft cloth and mild detergent in warm water.

Do not use appliance wax, polish, bleach, or other products containing chlorine on stainless steel. Stainless steel can be cleaned with a commercially available stainless steel cleaner. A spray-on stainless steel cleaner works best. Do not allow the Stainless Steel Cleaner and Polish to come into contact with any plastic parts such as the trim pieces, dispenser covers, or door gaskets. If unintentional contact does occur, clean the plastic part with a sponge and mild detergent in warm water. Dry thoroughly with a soft cloth.
For silver-accented plastic parts, wash with soap or other mild detergents. Wipe clean with a sponge or damp cloth. Do not use scouring pads, powdered cleaners, bleach, or cleaners containing bleach as these products can scratch and weaken the paint finish. Replace the base grille when finished.

[amalinkspro_table id=”32446″ new-window=”on” nofollow=”on” addtocart=”off” /]

Reference Links

View Full User Guide: Jayco Alante 2023 User Manual

Download Manuals: https://www.jayco.com/manuals