Jayco Alante 2023 Water Heater Instruction
The Jayco Alante 2023 has a water heating system that works well and is reliable. This makes life on the road nice and easy. The water heater, which is usually driven by propane, has a tank that can hold about 6 to 10 gallons of hot water, which is enough for many different uses. With temperature options that can be changed, users can choose how hot they want their water to be. The heater can be turned on by hand or with a switch, making it easy to use. Even though most water heaters run on propane, some types may also be able to run on electricity. With safety features like pressure release valves, the machine can be used without worry. Whether you want to take a nice shower or wash dishes while you’re on the road, the water heater in the Jayco Alante 2023 is ready to give you comfort and efficient performance.
Water Heater
Your RV is equipped with a tank (storage) water heater.
Warning
- Hydrogen gas may result if you have not used the water heater for two weeks or more. HYDROGEN GAS IS EXTREMELY FLAMMABLE. To reduce the risk of injury under these conditions, open the hot water faucet for several minutes at the kitchen sink before you use any electrical appliance connected to the hot water system. If hydrogen is present, you may hear what sounds like air escaping through the pipe as the water begins to flow. Hydrogen gas may be present even after the water has been drained from the water heater tank. Open the faucet at the sink and allow the system to vent for five to ten minutes. Do not smoke or have any open flame near the open faucet while venting. On DSI water heater models, make sure the switch is OFF.
- Do not alter the operation or change the design/construction of your water heater. For your safety, only factory-authorized parts should be used on your water heater. Accessories marketed for recreation vehicles, such as “add-on” electric heating elements, are not recommended by the manufacturer. Such items are not approved to be installed and could create an unsafe condition and will void all warranties.
- If you smell propane gas then STOP! and follow the procedures listed in the Propane System section before attempting to operate the water heater.
Tank (Storage) Water Heater
The water heater manufacturer has preset the sensing limit to maintain the water temperature when the water heater is activated. Read the safety and operating information in the manufacturer’s user guide before attempting to activate the water heater.
Gas/Electric DSI Tank (Storage) Water Heater System
Make sure the water heater is filled with water before use as even momentary operation of the water heater without water in it may result in damage to the tank and/or controls. Always open both the hot and cold water faucets when filling the fresh water tank to allow air pockets to be forced out of the water heater. The thermostat on your water heater is not adjustable and is designed to maintain a water temperature of 130°F (54°C).
The water heater does not have a pilot. It is equipped with an ignition device that automatically lights the burner. Do not try to light the burner by hand.
Operating instructions
- Turn OFF all electric power to the water heater.
- Turn OFF the propane supply. Wait five minutes for the propane to clear the area. If you smell propane STOP! Follow the safety instructions listed in the manufacturer’s owner’s manual. If you do not smell propane, go to the next step.
- Turn ON the propane supply.
- Turn ON the electrical power to the water heater. Turn the switch to the “ON” position. If the burner does not light, the system will automatically attempt two more tries for ignition before lock-out occurs. NOTE: Each ignition cycle will have a 15 second purge before spark cycle if the system is a three-try system.
- If lock-out occurs before the main burner lights, turn the water heater control switch to OFF, wait five seconds and turn the switch to the ON position. This will restart the ignition cycle.
- The first start-up of the heater may require several ignition cycles before all the air is purged form the propane lines.
If the burner will not come on, the following items should be checked before calling a ser-vice person:
- See if the switch is turned OFF.
- Make sure the propane supply to the water heater is not empty or turned OFF. Check to see if the reset button on the water heater ECO is tripped.
Water Heater Switch
The “propane GAS” switch enables the propane operation of the water heater, and the “ELEC-TRIC” switch enables electric operation.
NOTE:
Water heaters in some models will ONLY have a single LP Gas water heater switch. These units will not heat water electrically.
Water Heater Bypass
Your RV may be equipped with a water heater bypass. This three-valve system is located at either the water heater or on the utility center panel depending on your model. For detailed information refer to the Utility Center or Fresh Water System sections.
The odor from the hot water system
Many water supplies contain sufficient amounts of sulfur to produce an odor, often called “sulfur water”. Sulfur water can be caused by chemical action or by bacteria. Generally, sulfur water is not harmful, only unpleasant to smell. Refer to the water heater manufacturer’s manual for details on eliminating the odor from sulfur water. The odor from sulfur water is not a service problem.
FAQ
A: The Jayco Alante 2023 typically comes with a standard propane-powered water heater.
A: The tank capacity can vary, but it’s often around 6 to 10 gallons.
A: Yes, most water heaters in RVs like the Jayco Alante 2023 have adjustable temperature settings.
A: The water heater is usually ignited manually or electronically using a pilot light or an electronic ignition system.
A: Some models might offer a dual-power option, allowing you to run the water heater on either propane or electricity.
A: Yes, it’s important to follow the manufacturer’s guidelines for winterizing to prevent freezing and potential damage. This might involve draining the tank and adding antifreeze.
A: The heating time can vary based on factors like the initial water temperature and the heater’s capacity, but it typically takes around 15-30 minutes.
A: Yes, you can adjust the temperature using the controls provided.
A: Yes, water heaters usually come with safety features like pressure relief valves to prevent overpressure and potential explosions.
A: It’s generally not recommended to operate the water heater while driving to ensure safety and conserve energy.
A: Regular maintenance includes flushing the tank, checking for leaks, and inspecting the burner or heating element.
A: If you have the necessary skills, you might be able to replace it yourself, but it’s often best to have a professional do it to ensure proper installation.
A: Check the propane supply, ignition system, and fuses. If you can’t identify the issue, consult the owner’s manual or contact a service professional.
A: In some cases, it might be possible to upgrade, but it could involve modifications and additional considerations.
A: The warranty coverage can vary, so it’s important to check with the manufacturer or dealer to understand the specific terms for the water heater in the Jayco Alante 2023.
Useful Link
View Full PDF: 2023 Jayco Alante User Manual | Auto User Guide
Jayco Alante 2023 Introduction User Manual