2019 Jeep Compass Fuses and Fuse Box | Replacing a blown fuse
The 2019 Jeep Compass has a strong electrical system, and its fuse box plays an important role in protecting various components by preventing electrical overload. In this introduction, we will look at fuses and the fuse box, explaining their importance and providing essential information on how to replace a blown fuse. The fuse box in the 2019 Jeep Compass is an essential part of the vehicle’s electrical system. Fuses are intended to protect electronic systems and components by cutting off the electrical circuit in the event of a power surge or overload. Each fuse is assigned to a specific electrical function, such as the lights or the power windows, to ensure that a fault in one system does not affect the entire vehicle.
2023 JEEP COMPASS Specs, Price, Features, Mileage (Brochure)
Fuses and Fuse Box
FUSES
WARNING!
- When replacing a blown fuse, always use an appropriate replacement fuse with the same amp rating as the original fuse. Never replace a fuse with another fuse of higher amp rating. Never replace a blown fuse with metal wires or any other material. Do not place a fuse inside a circuit breaker cavity or vice versa. Failure to use proper fuses may result in serious personal injury, fire and/or property damage.
- Before replacing a fuse, make sure that the ignition is off and that all the other services are switched off and/or disengaged.
- If the replaced fuse blows again, contact an authorized dealer.
- If a general protection fuse for safety systems (air bag system, braking system), power unit systems (engine system, transmission system) or steering system blows, contact an authorized dealer.
General Information
The fuses protect electrical systems against excessive current.
When a device does not work, you must check the fuse element inside the blade fuse for a break/melt.
Also, please be aware that when using power outlets for extended periods of time with the engine off may result in vehicle battery discharge.
- Fuse Element
- Blade Fuse with a good/functional fuse element.
- Blade fuse with a NOT functional / BAD fuse element (blown fuse).
Fuse Location
The fuses are grouped into controllers located in the engine compartment.
Engine Compartment Fuses/Distribution Unit
The engine compartment fuse panel is located on the left side of the engine compartment.
- Cover Screw
- Fuse Cover
Removing Fuse Cover and Locking Screw Proceed as follows:
- Slowly turn the screw counterclockwise.
- Slowly release the screw.
- Remove the fuse cover by sliding it upward.
Mounting Fuse Cover and Locking Screw Proceed as follows:
- Properly secure the fuse cover to the box, slide completely from top to bottom.
- Fully depress the screw, using the special screwdriver supplied.
- Slowly turn the screw clockwise.
- Release the screw.
Fuse Cover Tabs
Fuse Cover
| Cavity | Maxi Fuse | Cartridge Fuse | Mini Fuse | Description |
| F01 | 70 Amp Tan | – | – | Module Body Computer |
| F02 | 70 Amp Tan | – | – | Module Body Computer, Rear Distribution Units |
| F03 | – | 30 Amp Pink with HID Lamps
20 Amp Blue with- out HID Lamps |
– | Supply Body Computer, HID Lamps |
| F04 | – | 40 Amp Tan | – | Brake Control Electronics Module |
| F05 | – | 40 Amp Tan | – | PTC Heater |
| F06 | 40 Amp Orange | – | – | Starter Relay |
| F07 | 40 Amp Orange | – | – | Rear Distribution Unit For Trailer Tow Usage |
| F08 | – | 30 Amp Pink | – | Supply For TCM, AGSM, Steering Control |
| F09 | – | – | 7.5 Amp Brown | ECM, TCM, Radiator Fan Control |
| F10 | – | – | 20 Amp Yellow | Horn |
| Cavity | Maxi Fuse | Cartridge Fuse | Mini Fuse | Description |
| F11 | – | – | 20 Amp Yellow – 1.4L Gas & Diesel Engines
25 Amp Clear – 2.4 L Engines/UREA |
ECM/PCM/UREA
Fuel Injectors |
| F14 | – | – | 7.5 Amp Brown | Diesel Crankcase Heater |
| F15 | 40 Amp Orange | – | – | Brake Control Mod- ule Pump |
| F16 | – | – | 10 Amp Red | Engine Control Mod- ule Power, Automatic Transmission |
| F17 | – | – | 10 Amp Red | Engine Secondary Loads |
| F18 | – | – | 20 Amp Yellow | 12V Rear Cargo Out- let Ignition Powered |
| F19 | – | – | 7.5 Amp Brown | Air Conditioner Compressor |
| F20 | – | – | 20 Amp Yellow | Cigar Lighter |
| F21 | – | – | 20 Amp Yellow | Fuel Pump |
| Cavity | Maxi Fuse | Cartridge Fuse | Mini Fuse | Description |
| F22 | – | – | 20 Amp Yellow – Gas Engine
15 Amp Blue – Die- sel Engine |
Gas – Ign Coil/Fuel Injector Diesel- Diesel Components |
| F23 | – | – | 30 Amp Green | Window Heater Grid |
| F24 | – | – | 15 Amp Blue | Electronic Unit Sup- ply Automatic Trans- mission |
| F30 | – | – | 20 Amp Yellow (Customer Select- able, Move From F18) | 12V Rear Cargo Out- let Constant Battery Powered |
| F81 | 60 Amp Blue | – | – | Glow Plug Module, DDCT SDU Battery Feed |
| F82 | – | 40 Amp Green | – | Diesel Fuel Filter Heater |
| F83 | – | 40 Amp Green | – | HVAC Fan |
| F84 | – | – | 30 Amp Green | Power Supply All Wheel Drive |
| F87 | – | – | 5 Amp Tan | Gear Selector Auto- matic Transmission |
| Cavity | Maxi Fuse | Cartridge Fuse | Mini Fuse | Description |
| F88 | – | – | 7.5 Amp Brown | Heated Outside Mir- rors |
| F89 | – | – | 30 Amp Green | Heated Rear Window |
| F90 | – | – | 5 Amp Tan | IBS Sensor (Battery State Of Charge) |
| Fxx | – | – | 10 Amp Red | Dual Battery Control Relay With NON DDCT Trans |
| 7.5 Amp Brown | Dual Battery Control Relay With DDCT Trans |
The Fuse Box has additional ATO fuse holders installed on the bottom of the box.
| Cavity | ATO / UNIVAL Fuse | Description |
| F1 | 5 Amp Biege | Drivetrain Control Module (4×4/ AWD) |
| F2 | 10 Amp Red | ECM — Start Diagnostic Sense |
| F3 | 2 Amp Grey | Mod Steering Control |
Interior Fuses
The interior fuse panel is located in the passenger compartment on the left side dash panel under the instrument panel.
| Cavity | Blade Fuse | Description |
| F31 | 7.5 Amp Brown | Occupant Restraint Controller |
| F33 | 20 Amp Yellow | Window Motor Passenger |
| F34 | 20 Amp Yellow | Window Motor Driver |
| F36 | 20 Amp Yellow | Intrusion Module/Siren, Radio, UCI/USB Port, VSU, Cli- mate Control, Electronic Steering Lock, Power Folding Mirrors, Security Gateway/DTV |
| F37 | 10 Amp Red | Instrument Panel Cluster, Drivetrain Control Module, Adaptive Cruise, ECC (HVAC) Blower |
| F38 | 20 Amp Yellow | Door Lock/Unlock, Liftgate Release |
| F42 | 7.5 Amp Brown | Brake System Module, Electric Power Steering |
| F43 | 20 Amp Yellow | Washer Pump Front And Rear |
| F47 | 20 Amp Yellow | Rear Left Window Lifter |
| F48 | 20 Amp Yellow | Rear Right Window Lifter |
| F49 | 7.5 Amp Brown | Park Assist, Blind Spot, Voltage Stabilizer, Humidity Sensor, Electronic Steering Lock, Temp Sense, Mirror, Heated Seats, Light And Rain Sensor, Start Stop Switch |
| Cavity | Blade Fuse | Description |
| F50 | 7.5 Amp Brown | Occupant Restraint Controller |
| F51 | 7.5 Amp Brown | Electronic Climate Control, Occupant Classification, Rear View Camera, Climate Control, Headlamp Leveling, Ter- rain Select, Heated Rear Window, Trailer Tow, Haptic Lane Departure |
| F53 | 7.5 Amp Brown | Keyless Ignition Node Module, Electric Park Brake, RF Hub, Cluster |
| F94 | 15 Amp Blue | Lumbar Adjust Driver Seat, Power Outlets |
Rear Cargo Fuse/Relay Distribution Unit
To access the fuses, remove the access door from the left rear panel of the rear cargo area.
The fuses may be contained in two units. Fuse holder No. 1 is located closest to the rear of the vehicle and fuse holder
No. 2 (if equipped with trailer towing) is located closest to the front of the vehicle
1 — Fuse Holder No. 1
2 — Fuse Holder No. 2
Fuse Holder No. 1
| Cavity | Mini Fuse | Description |
| F1 | 30 Amp Green | Power Inverter |
| F2 | 30 Amp Green | Memory Seat |
| F3 | 20 Amp Yellow | Sun Roof – If Equipped |
| F4 | 30 Amp Green | Power Seat (Passenger Side) |
| F5 | 30 Amp Green | Power Seat (Driver Side) |
| F6 | 7.5 Amp Brown | Power Lumbar (Power Seats) |
| F7 | 15 Amp Blue | Heated Steering Wheel / Ventilated Seats |
| F8 | 20 Amp Yellow | Heated Seats |
Fuse Holder No. 2
| Cavity | Mini Fuse | Description |
| F1 | 10 Amp Red | TTM IGN Feed |
| F5 | 15 Amp Blue | Controller Exterior Lighting Lights (Drivers Side) |
| F6 | 15 Amp Blue | Controller Exterior Lighting Lights (Passenger Side) |
| F7 | 10 Amp Red | TTM Jumper Battery Feed |
On the Rear Cargo Fuse/Relay Distribution Unit bracket, there is a Maxi Fuse holder for the Power Liftgate and an ATO / Uni Val fuse holder for the HIFI Audio System
| Cavity | Maxi Fuse | Description |
| F01 | 30 Amp Green | Power Liftgate |
| Cavity | ATO / Uni-Val Fuse | Description |
| F02 | 25 Amp Clear | HIFI Audio System |
FAQs
The fuse box in the 2019 Jeep Compass is typically found in the engine compartment.
To open the fuse box cover, gently press the tabs on the sides and lift to access the fuses.
A fuse puller or needle-nose pliers are usually sufficient.
Look for a broken metal strip inside the fuse. If it’s broken, the fuse is probably blown.
The 2019 Jeep Compass typically uses mini blade fuses.
Always replace fuses with the same amp rating. Using a higher amperage fuse can cause electrical system damage.
The fuse’s amp rating is usually indicated on the top or end.
There could be an electrical issue. Consult a professional mechanic for diagnostics.
Follow the recommended color coding for fuses. Different colors may indicate varying amp ratings.
To avoid electrical shock, disconnect the battery before replacing fuses.
Insert the puller over the blown fuse, gently squeeze, and pull it out.
Seek professional help. There could be an underlying electrical issue that requires expert diagnosis.
Choose reputable brands that meet your vehicle’s recommended specifications.
Inspect fuses regularly and replace any that are blown. Consider checking them during regular maintenance.
Useful Links
View Full PDF: 2019 Jeep Compass Owner’s Manual| Auto User Guide
2023 JEEP COMPASS Specs, Price, Features, Mileage (Brochure)