Maserati GranTurismo 2024 Punctured Tire User Manual
Introduction
The striking design and thrilling driving experience of the Maserati GranTurismo 2024 have earned it widespread acclaim. It truly stands out on the road thanks to its slender and aerodynamic bodylines and strong engine. Nevertheless, no matter how well a car is made, running into a flat tire can be a frustrating experience for any driver. Driving over jagged objects or slamming into potholes on the road are just a couple of the causes of a punctured tire. It is crucial to maintain composure and act quickly to resolve the situation when faced with this problem. The Maserati GranTurismo 2024 needs to be well-prepared, knowledgeable, and equipped in order to handle a punctured tire. Maserati cars come with sophisticated tire pressure monitoring systems that can identify sudden drops in tire pressure and warn the driver. Finding a secure location to stop in order to check the damaged tire is imperative as soon as you receive this warning. If your vehicle has a tire repair kit, you might use it if the puncture is obvious and the tire can be safely repaired right away.
It’s important to remember, though, that occasionally the puncture might be too bad to be temporarily repaired. To get the right help in these situations, it is advised to call roadside assistance or a reputable tire service. These professionals are equipped with the knowledge and know-how to handle tire replacements or repairs quickly, getting your Maserati GranTurismo back on the road in no time.
Punctured Tire
The vehicle can be equipped with a tire repair kit or with a spare wheel, depending on the destination markets and on customer requirements.
Using Tire Repair Kit
Small punctures up to 6 mm (1:4”) in the tire tread can be sealed using the tire repair kit, fitted on the battery cover, inside of the boot compartment (see chapter “Tool Kit” in this section).
The kit consists of two parts:
- An electric compressor with pressure gauge and power cable;
A bottle containing sealant with hose to be connected to the punctured tire.
NOTE:
For the tire repair procedures with tire repair kit see instructions included in the kit.
This kit will provide a temporary tire seal, allowing you to drive your vehicle up to 10 km (6 miles) with a maximum speed of 80 km/h (50 mph).
CAUTION!
- Intruding objects (e.g., screws or nails) should not be removed from the tire, which could compromise the repair with the tire repair kit.
Do not use the tire repair kit if the tire shows lateral damages and/or the rim is damaged by driving with flat tire.
Tire repair kit can be used in outside temperatures down to approximately -20°C (-4°F).
Replace the tire repair kit sealant bottle prior to the expiration date (printed on the bottle label) to assure optimum operation of the system.
NOTE:
- The compressor power plug can be inserted either in the 12 V power outlet housed in the boot or inside the passenger compartment (see “Internal Equipment” in section “ Understanding the Vehicle”).
When having the tire serviced to the Service Network or to a tires service centre, advise who performs the operation that the tire has been sealed using the tire repair kit.
Using the Spare Wheel
The automatic levelling of pneumatic suspensions might create problems when it is necessary to lift the vehicle to replace the wheel featuring punctured tire with the emergency wheel supplied or with another wheel.
CAUTION!
Before mounting the spare wheel it is necessary to disable the suspension system by scrolling the user settings on MIA and selecting “Tire Jack Mode”
in “Suspensions” submenu. The tick next to selected item will indicate that this mode is active and pneumatic suspension system is disabled (for further details, refer to “Functions of Settings Menu on MIA” chapter in section “Dashboard Instruments and Controls”). After servicing, restore original conditions and eliminate the tick next to selected mode: in this way the pneumatic suspension system will go back to normal operation.
NOTE:
The spare wheel is supplied in aluminium or steel: the pictures show the one in aluminium.
The spare wheel is stored in the boot and is supplied deflated in order to limit the amount of space occupied. In the event of a tire puncture, proceed as follows.
- Stop the vehicle in a place that does not constitute a danger to traffic and where the wheel can be changed safely. The vehicle must be level and on firm ground.
Select the P (Park) mode and then engage manually the electric parking brake and move the ignition device to STOP position.
If necessary, turn the hazard warning lights on and place the warning triangle (if equipped) at the required distance.
WARNING!
- The jack should be used on level firm ground wherever possible.
It is recommended that the wheels of the vehicle be chocked, and that no person should remain in a vehicle that is being jacked.
If the vehicle has been stopped on a slope or an uneven surface, place chocks or other suitable items in front of or behind the wheels to stop the vehicle from moving. - Never start or run the engine with the vehicle on a jack.
No person should place any portion of their body under a vehicle that is supported by a jack.
Release the straps that anchor the spare wheel bag to the boot compartment floor.
Remove the bag from the boot compartment.
Remove the compressor from the tire repair kit in the battery cover of the boot compartment.
- Remove the spare wheel and other tools from inside the bag.
Spare Wheel Installation
- Take the spanner, then loosen anticlockwise by approximately one turn the five bolts on the wheel to be changed. In case a wheel security stud bolt is installed, it can only be removed by using the specific fitting spanner insert provided with the “Wheel Security Stud Bolt Kit”, available in the “Genuine Accessories” range. In this case, the insert must be installed on the kit spanner.
Place the jack near the wheel to be changed as illustrated. Make sure that the head of the jack is correctly inserted in one of the slots 1 or 2 under the longitudinal member.
WARNING!
- Never position yourself under a jacked vehicle.
Jack wrong positioning can cause vehicle accidental fall, with consequent severe risk for operator’s safety and damages to vehicle body.
Never use the jack to carry out maintenance or repairs under the vehicle.
Insert the lever in the jack.
Turn clockwise the lever of the jack until the wheel is raised a few centimetres off the ground.
- Completely unscrew the five bolts and remove the wheel.
Make sure that the contact surfaces between spare wheel and hub are clean and free of impurities.
Fit the spare wheel with the valve stem side out and secure it with the five bolts previously removed, without tightening them.
Remove from the compressor case the inflation hose and the cable with a plug for the power outlet.
Unscrew the valve cap of the spare wheel and screw the fitting of the inflation hose onto the valve.
Insert the plug inside one of the available power outlets fitted in the boot or passenger compartment.
Set the ignition device in ON position.
Turn the compressor on by pressing the switch.
Stop the compressor pressing switch again, when the pressure indicated by the gauge reaches the recommended level (see chapter “Tire Inflation Pressure” in section “Technical Specifications”) and screw the cap on the spare wheel valve.
CAUTION!
- In order to obtain a more accurate reading, the compressor should be switched off when checking the tire pressure of the spare wheel on the pressure gauge.
Do not run the compressor for more than 20 minutes: there is a risk it could overheat. Also, prolonged power absorption may discharge the battery, subsequently preventing the engine from starting.
The compressor has been designed exclusively to inflate spare wheels; do not use it to inflate air mattresses, dinghies etc. - Turn anticlockwise the lever of the jack to lower the vehicle and remove the jack.
Fully tighten clockwise the bolts, alternately tightening diametrically opposite.
WARNING!
- Observe the tightening torque for the bolts securing the spare wheel (120 ± 12 Nm/ 88,5 ± 9 lbf·ft).
Bolts must be tightened only after vehicle is back to ground, so as to prevent it from falling down
due to the force exerted for bolt tightening. Failure to comply with this recommendation can cause operator injuries.
WARNING!
- The spare wheel must only be used to travel the distance required to reach a service station, where the punctured tire can be repaired or replaced.
Do not exceed a maximum speed of 80 km/h (50 mph) when using the spare wheel, as indicated on the label applied on it; when this limit is exceeded, the stability, road holding and braking of the vehicle will be compromised. Avoid accelerating to full speed, heavy braking and fast cornering.
The spare wheel must be inflated to the recommended tire pressure (see chapter “Tire Inflation Pressure” in section “Technical Specifications”).
For safety reasons, it is absolutely forbidden to drive with more than one spare wheel fitted on the vehicle.
Snow socks cannot be fitted on the spare wheel.
The spare wheel can travel a maximum of 3000 km (1800 mi).
To Refit the Standard Wheel with Repaired or Replaced Tire
- Following the procedure and the caution described above, raise the vehicle and remove the spare wheel reusing the supplied spanner.
- Fit the standard wheel with repaired or replaced tire.
Tighten the original bolts on the wheel.
Lower the vehicle and remove the jack.
Fully tighten the bolts, alternately tightening diametrically opposite.
- Place all the tools used in the container and insert it in spare wheel.
Insert the assembly into the bag and close the upper zip.
Position and secure the bag on the ground coverage of the boot compartment with the appropriate straps.
CAUTION!
Always make sure that you have closed the zip to prevent any tools from coming out while driving and damaging the coverings of the boot compartment.
FAQs
- What should I do if I get a punctured tire in my Maserati GranTurismo 2024?
If you get a flat tire, pull over in a safe location, check the tire, and decide whether it can be fixed temporarily or if you need professional help. - How do I know if I have a punctured tire?
A tire pressure monitoring system on the Maserati GranTurismo 2024 warns you if there is a sudden drop in tire pressure, which could be a sign of a possible puncture. - Can I use a tire repair kit in my Maserati GranTurismo 2024?
A tire repair kit can be used if the puncture is small and the tire can be safely repaired. However, it is always advised to read the owner’s manual and adhere to the manufacturer’s guidelines - How long can I drive on a punctured tire?
A prolonged period of time should be avoided when driving on a punctured tire. It is unsafe to drive on a flat or severely damaged tire because it can harm the wheel even more. - Should I replace a punctured tire or repair it?
Whether or not the tire can be repaired depends on the size and location of the puncture. Although larger or sidewall punctures may necessitate tire replacement, small punctures in the tread area can frequently be repaired. - Can I drive on a repaired tire in my Maserati GranTurismo 2024?
You can drive on a tire if it has been repaired correctly and complies with safety requirements. To make sure the repair was done properly, it is advised to speak with a reputable tire service. - Can I drive with a temporary spare tire in my Maserati GranTurismo 2024?
A temporary spare tire might not be included with the Maserati GranTurismo 2024. It might instead come with a tire repair kit. To learn about the choices available, consult the vehicle’s manual. - How do I use a tire repair kit in my Maserati GranTurismo 2024?
A tire repair kit’s specific instructions may differ. For comprehensive instructions on how to use the kit properly, consult the owner’s manual for your car. - Is roadside assistance included with the Maserati GranTurismo 2024?
Depending on the specific warranty or service plan you have with Maserati, roadside assistance may or may not be included. To verify the information, consult your warranty paperwork or get in touch with your dealer. - How long does it usually take for roadside assistance to arrive?
Depending on your location and the service provider, the response time for roadside assistance may vary. For an estimated arrival time, it is best to get in touch with them directly. - Can I change a tire myself in my Maserati GranTurismo 2024?
While changing a tire on your own is possible, it is advised to refer to the owner’s manual and follow the manufacturer’s guidelines. In some circumstances, getting in touch with a reputable tire service may be your best bet. - Where can I find a replacement tire for my Maserati GranTurismo 2024?
A reliable tire retailer or an authorized Maserati dealership can assist you in locating the right replacement tire for your GranTurismo 2024. - Can I use any brand of tire as a replacement for my Maserati GranTurismo 2024?
It is advised to use tires that adhere to the standards and specifications established by Maserati for your GranTurismo model. For assistance, consult the owner’s manual or get in touch with a certified Maserati dealersh - How often should I check the tire pressure in my Maserati GranTurismo 2024?
Regular tire pressure checks are necessary for the best performance and safety. The tire pressure should be checked at least once per month or before long trips. - Can I prevent punctured tires in my Maserati GranTurismo 2024?
While it’s not always possible to completely prevent tire punctures, maintaining proper tire pressure, avoiding potential road hazards, and using defensive driving techniques can all help reduce the likelihood of experiencing one.
Useful Links
Download Manuals: On-Board Owner Documentation | Maserati
2023 Maserati Granturismo Specs, Price, Features, Mileage (Brochure)
Related Article:
2023 Maserati GRECALE Specs, Price, Features, Mileage (Brochure)
2023 Maserati Ghibli Specs, Price, Features, Mileage (Brochure)
2023 Maserati Levante Specs, Price, Features, Mileage (Brochure)
2023 Maserati Quattroporte Specs, Price, Features, Mileage (Brochure)