2019 Mitsubishi Mirage G4 Warning Lights and Symbols Guide

2019 Mitsubishi Mirage G4 Warning Lights and Symbols Guide

A variety of warning lights and symbols are included with the 2019 Mitsubishi Mirage G4 to inform drivers of possible problems or statuses of various systems. These indicators assist drivers stay informed about the condition and functionality of their vehicle and are essential communication tools. It is crucial to comprehend the significance of every warning light in order to preserve the vehicle’s functionality and safety. These indicators, which range from tyre pressure alerts to engine-related warnings, are essential for informing drivers of any possible problems that could need to be fixed. Acquainting yourself with these alerts will enable you to react quickly to any issues that may surface while operating your Mitsubishi Mirage G4. Pay attention to the messages that your car sends out through these crucial warning lights and symbols to remain informed, stay safe, and stay proactive.

2023 MITSUBISHI MIRAGE G4 Specs, Price, Features, Mileage (Brochure)

Indication and warning lamps (multi-information display)

1. High beam indicator
2. Electric power steering system warning light
3. Tire pressure monitoring system warning light
4. Turn signal indicators/Hazard warning lights
5. Front fog light indicator
6. Door-ajar warning light
7. Supplemental Restraint System (SRS) warning light
8. High coolant temperature warning light (red)
9. Low coolant temperature indicator (green)
10. Oil pressure warning light
11. Engine malfunction indicator (“SER-VICE ENGINE SOON” or “Check engine light”)
12. Charging system warning light
13. Brake warning light
14. Anti-lock braking system warning light
15. Multi-information display
16. Driver’s seat belt reminder/warning light
17. Cruise control indicator
18. Active stability control (ASC) indicator/warning light
19. Washer fluid level warning light
20. Active stability control (ASC) OFF indicator/warning light
21. Position indicator
22. ECO indicator 
23. For details, refer to “Warning activation”
24. For details, refer to “Warning activation”

Indication lamps Mirage G4

Turn signal indicators/Hazard warning lights

The arrows will flash in time with the corre-sponding exterior turn signals when the turn signal lever is used.
Both arrows will flash when the hazard warning flasher switch is pressed.

NOTE

• If the indicator flashes faster than usual or if the indicator stays on without flashing, check for a malfunctioning turn signal light bulb or turn signal connection.

High-beam indication lamp
A blue light comes on when the headlights are on high beam.

Front fog lamp indication lamp
This indicator comes on while the front fog lights are on.

Position lamp indication lamp
This indicator light illuminates while the parking lights are on.

Low coolant temperature indicator – green
This indicator comes on in green while the coolant temperature is low.

NOTE

• When the indicator goes out, this should be used as a rough indication of when the heating starts working.

ECO indicator
This indicator comes on while fuel-efficient driving is achieved.

2019 Mirage G4 Warning lights

Brake warning light and buzzer
This light comes on when the ignition switch is turned to the “ON” position (engine off) or the operation mode is put in ON.
When the engine is started, the light should go off a few seconds later.
The warning light also illuminates after starting the engine under the following condi-tions.

• When the parking brake is still applied.
• When the brake fluid level is low.
• When the brake system circuit is not working properly.

When the vehicle is moving at more than 5 mph (8 km/h) and the parking brake applied, a buzzer will sound to inform the driver that the parking brake is not properly released.
Before driving, be sure that the parking brake is fully released and the brake warning light is off.

CAUTION

• If the brake warning light and the Anti-lock braking system warning light are illuminated at the same time, the braking force distribution function will not operate, the vehicle may be destabilized during sudden braking under the following conditions.
  • When the brake warning light does not go out even when the parking brake is released.
  • When the brake warning light stays on while driving.
    If the above occurs, avoid sudden braking and high-speed driving. Park the vehicle in a safe place, and contact an authorized Mitsubishi Motors dealer or a repair facility of your choice as soon as possible.
    The vehicle should be brought to a halt in the following manner when brake performance deteriorates.
• Confirm that the vehicle slows down when you press down on the brake pedal harder than usual. In some cases, the brake pedal may go all the way to the floor.
  • Should the brakes fail, use engine braking to reduce your speed and slowly apply the parking brake.
    Depress the brake pedal to illuminate the stop lights and to alert the vehicles behind you.

Engine malfunction indicator (“SERVICE ENGINE SOON” or “Check engine light”)
This indicator is a part of the onboard diag-nostic (OBD) system which monitors the emissions, engine control system or continuously variable transmission (CVT) control system. If a problem is detected in one of these systems, this indicator illuminates or flashes. When the ignition switch is turned to the “ON” position or the operation mode is put in ON, this indicator normally comes on and goes off after the engine has started.
This indicator will come on if the fuel tank filler cap is not properly tightened. If this indicator comes on and stays on after refueling, stop the engine and check that the cap is properly tightened. (Turn the cap clockwise until you hear clicking sounds.)
If this indicator does not go off after several seconds or lights up while driving, have the system checked as soon as possible at an authorized Mitsubishi Motors dealer or a repair facility of your choice.

CAUTION

• Driving for a long time with the engine malfunction indicator on may cause more damage to the emission control system. This could also affect fuel economy and drivability.
• If this indicator does not come on when the ignition switch is turned to the “ON” position or the operation mode is put in ON, have the system checked at an authorized Mitsubishi Motors dealer or a repair facility of your choice.
• If the engine malfunction indicator comes on while the engine is running, avoid driving at high speeds.
  During vehicle operation with the indicator on, the vehicle may not accelerate when you depress the accelerator pedal.
  When the vehicle is stationary with the indi-cator on, you must depress the brake pedal more firmly than usual since the engine idling speed is higher than usual and a vehi-cle with a CVT has a stronger tendency to creep forward.

NOTE

• Do not disconnect the battery cable when the engine malfunction indicator (“SERVICE ENGINE SOON” or “Check engine light”) is on.
  The engine electronic control module stores critical OBD information (especially exhaust emission data), which may be lost if the bat-tery cable is disconnected while the engine malfunction indicator is on. This will make it difficult to diagnose the cause of future problems.

Charging system warning light
This light comes on in the event of a malfunction in the charging system or when the ignition switch is turned to the “ON” position (engine off) or the operation mode is put in ON. When the engine is started, the light should go out. Check to make sure that the light has gone out before driving.

CAUTION

• If the warning light stays on while the engine is running, park your vehicle in a safe place as soon as possible and contact an authorized Mitsubishi Motors dealer or a repair facility of your choice to have the system checked.

Oil pressure warning light
This light comes on when the engine oil pressure is below normal. If the light stays on while driving, stop the engine as soon as possible. Do not run the engine until the cause of the low oil pressure is corrected.

CAUTION

• If this light comes on when the engine oil level is not low, have your vehicle checked at an authorized Mitsubishi Motors dealer or a repair facility of your choice.
  This warning light does not show the amount of oil in the crankcase. This can only be determined by checking the oil level with the dipstick with the engine turned off.

High coolant temperature warning light red
This light comes on in red if the coolant temperature becomes excessively high.

CAUTION

• If the light comes on during vehicle opera-tion, it indicates that the engine is possibly overheating. Continued driving could make the engine fail. Immediately stop the vehicle in a safe place and take appropriate action.

NOTE

• The high coolant temperature warning light may illuminate when the vehicle has been driven at high speeds or on hilly roads. This illuminating does not necessarily indicate a problem. It should stop if you keep the engine running for a while or continue driv-ing the vehicle.

Door-ajar warning light and buzzer
This light comes on when any door or the liftgate is open or not completely closed. When the vehicle is moving at more than 5 mph (8 km/h) and any door or the liftgate is open or ajar, a tone will sound 4 times to inform the driver that any door or the liftgate is not properly shut.

CAUTION

• Before driving, make sure that the door-ajar warning light is off.

NOTE

• When the auto cutout function of the doom light is been activated, the light goes out automatically after about 30 minutes.

Washer fluid level warning light (if so equipped)
This light comes on when the washer fluid is running low.
If the light comes on, replenish the container with washer fluid.

Combination headlamps and dipper switch

Headlamps
NOTE
Rotate the switch to operate the lights.

The combinations of switch operations and illuminated lights differ by the following conditions.

Except for vehicles equipped with daytime running lights

OFF	All lights off
	Parking, tail, front and rear side- marker lights, license plate and instrument panel lights on
	Headlights and other lights on

Vehicles equipped with daytime running
lights

[When the engine is started, and the parking brake is released]

The daytime running lights will be illuminated:

OFF	The daytime running lights illuminated
	The daytime running lights illuminated Parking, tail, front and rear side marker lights, license plate and instrument panel lights on
	Headlights and other lights on

NOTE

• Once the daytime running light comes on, they do not go out until the ignition switch is turned to the “OFF” or “ACC” position or the operation mode is changed to OFF or ACC.

[When the engine is not running, or when the engine is running but the parking brake is not released]

The engine starts when the lights are off.

OFF	All lights off
	Parking, tail, front and rear side marker lights, license plate an instrument panel lights on
	Headlights and other lights on

NOTE

• Do not leave the headlights and other lights on for a long period when the engine is not running. The battery will run down.
• When it rains, or when the vehicle has been washed, the inside of the lens sometimes becomes foggy. This is the same as when window glass mists up on a humid day, and does not indicate a problem. When the light is switched on, the heat will dry out the fog. However, if water collects inside the light, have it checked by an authorized Mitsubishi Motors dealer or a repair facility of your choice.

Light auto-cutout function (headlights and other lights)

• If the following operation is performed with the combination headlights and dimmer switch in the “ ” or “
  ” position, the lights automatically turn off.

[Except for vehicles equipped with the F.A.S.T.-key]
The ignition switch is turned to the “OFF” or “ACC” position or the key is removed from the ignition switch and the driver’s door is opened.

[For vehicles equipped with the F.A.S.T.-key]

The operation mode is changed to OFF or ACC and the driver’s door is opened.

• If the following operation is performed with the combination headlights and dimmer switch in the “ ” or “ ” position, the lights automatically turn off after about 3 minutes.
  [Except for vehicles equipped with the F.A.S.T.-key]
  The ignition switch is turned to the “OFF” or “ACC” position or the key is removed from the ignition switch and the driver’s door is not opened.

[For vehicles equipped with the F.A.S.T.-key]
The operation mode is changed to OFF or ACC and the driver’s door is not opened.

NOTE

• The light auto-cutout function can be deactivated.
  See your authorized Mitsubishi Motors dealer for details.

When you want to keep the lights on:

If the combination of headlights and dimmer
switch is turned to the “ ” or “ ” position again after the engine is turned off, the about 3-minute auto-cutout function described above will not work. The lights (the parking lights, tail lights and license plate lights) will stay on and will not turn off automatically.

FAQs

Useful Links

View Full PDF: 2019 Mitsubishi Mirage G4 User Manual| Auto User Guide

2023 MITSUBISHI MIRAGE G4 Specs, Price, Features, Mileage (Brochure)

2019 Mitsubishi Mirage G4 Fuses and Fuse Box Guide