2019 Renault Captur Cluster Warning Lights User Guide
A complex cluster of warning lights is included on the 2019 Renault Captur to notify drivers of various car issues and malfunctions. These lights provide the important function of being indicators, giving vital details about the condition of the vehicle and guaranteeing safe and effective driving. It is essential for all Captur owners to comprehend the meanings behind these warning lights so they can act promptly when needed. Every light on the dashboard, from low tyre pressure to engine troubles, indicates something particular that can assist avert future issues and keep the car operating at its best. Drivers may prolong the life of their Renault Captur and improve their driving experience by becoming familiar with these warning lights and their meaning. To help you drive with assurance and peace of mind, let’s examine the 2019 Renault Captur’s major warning lights and discover what they indicate.
2023 Renault Traffic Specs, Price, Features, Mileage and Review
WARNING LIGHTS
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY.
Instrument panel A: lights up when the ignition is switched on.
With the lights on, you can adjust the brightness by turning the knob 1.
The warning light means you should drive very carefully to an approved dealer as soon as possible. If you fail to follow this recommendation, you risk damaging your vehicle.
In some cases, the appearance of a warning light is accompanied by a message.
Sidelight warning light
Main beam headlight tell-
Dipped beam headlight tell-tale 
Front fog light tell-tale
Rear fog light telltale
Left-hand direction indicator tell-tale
Right-hand direction indicator tell-tale
Warning light requires you to stop immediately, for your own safety, as soon as traffic conditions allow. Switch off the engine and do not restart it. Contact an approved Dealer.
Airbag warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it does not come on when the ignition is switched on or comes on when the engine is running, there is a fault in the system.
Contact your approved Dealer as soon as possible.
Low fuel level warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it lights up when driving, fill up with fuel as soon as possible. There is only approximately 30 miles (50 km) worth of fuel left.
If no lights or sounds are apparent, this indicates a fault in the instrument panel. This indicates that it is essential to stop immediately (as soon as traffic conditions allow). Ensure that the vehicle is correctly immobilised and contact an approved Dealer.
STOP light
This lights up when the ignition is switched on and goes out as soon as the engine is started. It comes on with other warning lights and/or messages and is accompanied by a beep.
It requires you to stop immediately, for your safety, as soon as traffic conditions allow. Switch off the engine and do not restart it.
Contact an approved Dealer.
Handbrake on and brake circuit incident warning light
This comes on when the ignition is switched on and goes out as soon as the handbrake is released.
If it comes on during braking and is accompanied by the warning light and a beep, it indicates that the fluid level in the circuit is low or that there is a braking system fault.
Stop as soon as traffic conditions allow and contact an approved Dealer.
Battery charge warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it comes on on the road, accompanied by
a warning light and a beep, this indicates an overload or discharge in the electrical circuit.
Stop as soon as traffic conditions allow and contact an approved Dealer.
Oil pressure warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it comes on on the road, accompanied by the warning light and a beep, stop immediately and cut the ignition.
Check the oil level. If the level is normal, the indicator light is being lit by something else. Contact an approved Dealer.
Warning light
This lights up when the ignition is switched on and goes out as soon as the engine is started. It can light up in conjunction with other indicator lights and/or messages on the instrument panel.
It means you should drive very carefully to an approved dealer as soon as possible. If you fail to follow this recommendation, you risk damaging your vehicle.
Electronic Stability Program (ESP) and traction control
system warning light
This lights up when the ignition is switched on and goes out after a few seconds.
There are several reasons for the warning light to come on: please refer to the information on “Driver correction devices and aids” in Section 2.
Toxic Fume Filter System Warning Light
On vehicles that are equipped with it, this light comes on when the engine is started and, depending on the vehicle, when the ignition is switched off if the vehicle is in the engine standby phase (Refer to the information on the “Stop and Start Function” in section 2) then goes out.
- If it lights up continuously, consult your approved dealer as soon as possible;
- if it flashes, reduce the engine speed until the light stops flashing. Contact your approved Dealer as soon as possible.
Refer to the information on “Advice: antipollution, fuel economy and driving” in Section 2.
Anti-lock braking warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it lights up when you are driving, it indicates a fault in the anti-lock braking system.
Braking will then be as normal, without the ABS. Contact an approved Dealer as soon as possible.
Coolant temperature warning light
This comes on when the ignition is switched on.
If it turns red, stop and let the engine idle for a minute or two.
The temperature should lower and the warning light should return to a blue colour. If not, stop the engine. Let the engine cool down before checking the coolant.
Contact an approved Dealer.
Preheating warning light (diesel version)
This should come on when the ignition is switched on. It indicates that the heater plugs are in operation.
It goes out when preheating is complete. The engine can be started.
Speed limiter and cruise control indicator lights
See the information on the “Speed limiter” and “Cruise control” in Section 2.
Engine standby warning light
Please see information about the “Stop and Start function” in Section 2.
Unavailability of engine standby warning light
Please see the information in the paragraph on “Stop and Start Function” in Section 2.
ECO mode warning light
This comes on when ECO mode is activated.
Please refer to the information on “Eco-driving” in Section 2.
Door(s) open warning light
Gear change indicator
This lights up to advise you to change to a higher gear (up arrow) or lower gear (down arrow).
Tyre pressure loss warning
Please refer to the information on the “Tyre pressure loss warning” in Section 2.
On display B
Passenger airbag ON
Please refer to the information on “Child safety: deactivating/activating the front passenger airbag” in Section 1.
Passenger airbag OFF
Please refer to the information on “Child safety: deactivating/activating the front passenger airbag” in Section 1.
Front seat belt reminder warning light
This lights up on the central display when the engine is started then if the driver’s or front passenger’s seat belt (if this seat is occupied) is not fastened and the vehicle has reached approxi-mately 12 mph (20 km/h), it flashes and a bleep sounds for around 2 minutes.
Note: an object placed on the passenger seat base may activate the warning light in some cases.
Rear seat belt reminder (depending on vehicle)
The warning light comes on on the central display, accompanied by a message on the instrument panel, indicating the number of seat belts buckled for approximately 30 seconds each:
- the vehicle is started;
- a door is opened;
- a rear seat belt is fastened or unfastened.
Check that the rear passengers are wearing seat belts and that the number of seat belt shown as fastened corresponds to the number of rear bench seat places occupied.
FAQs
The “Check Engine” light on the 2019 Renault Captur means that there might be a problem with the engine or pollution system.
The oil can icon means that the engine oil pressure or amount is low. To keep the engine from breaking down, it’s important to check the oil amount and add more if needed.
The 2019 Renault Captur’s battery warning light means that something is wrong with the charging system. This could mean that the battery or charger is broken. .
If your 2019 Renault Captur’s brake system warning light comes on, it could mean that there are problems with the brakes, like not enough brake fluid or worn brake pads.
The thermometer icon on the 2019 Renault Captur means that the engine is getting too hot. Before going on, you must stop, let the engine cool down, and check the water levels.
The airbag warning light in the 2019 Renault Captur could mean that there is a problem with the airbag system.
In the 2019 Renault Captur, an exclamation mark inside a circle usually means a general warning or a problem.
Someone is having trouble with the 2019 Renault Captur’s tracking system because the TPMS warning light is on.
The 2019 Renault Captur’s steering wheel with an exclamation mark on it usually means that the power steering system is broken.
In the 2019 Renault Captur, the fuel pump sign means that there isn’t enough fuel. .
In the 2019 Renault Captur, the key sign with an exclamation mark means that there is a problem with the immobilizer system
In the 2019 Renault Captur, the windshield washer fluid warning light means that there isn’t enough washer fluid in the system.
The 2019 Renault Captur’s traction control system (TCS) warning light means that there is a problem with the system that is supposed to keep the wheels from slipping.
The “door ajar” symbol means that one or more doors are not properly closed in the 2019 Renault Captur.
Useful Links
View Full PDF: Renault Captur 2019 User Manual|Auto User Guide
2023 Renault Traffic Specs, Price, Features, Mileage and Review