2022 Renault Clio User Manual

In the supermini class, the 2022 Renault Clio distinguishes out because to its fashionable look, effective performance, and array of contemporary amenities. The Clio, which is well-known for its small size and roomy interior, comes with a range of engine options, including diesel, gasoline, and a hybrid version, to meet the demands and preferences of drivers of all stripes. The car has an easy-to-use entertainment system that integrates with smartphones, and it has cutting-edge safety features including automated emergency braking and lane departure warning. Maintaining its position as a major participant in the competitive supermini market, the 2022 Clio is still a popular choice for individuals looking for a dependable and exciting driving experience in an urban setting because to its blend of comfort, practicality, and nimble handling.

STEERING WHEEL, POWER-ASSISTED

Power-assisted steering
Never drive with an inadequately charged battery.

Variable power-assisted steering
The variable power-assisted steering system is equipped with an electronic control system which alters the level of assistance to suit the vehicle’s speed. Steering is made easier during parking manoeuvres (for added comfort) while the force needed to steer increases progressively as the speed rises (for enhanced safety at high speeds).

Special feature of Stop and Start
With the engine on standby, power-assisted steering is no longer operational. In this case, it returns to its original state when the engine is restarted or when the speed exceeds 1 mph (1 km/h) (hill, slope etc.).

Note: the power-assisted steering depends on the driving mode selected in the “MULTI-SENSE” menu.

Front fog lights
Turn centre ring 4 on the stalk 1 until the symbol faces mark 3, then release it. The operation of the fog lights depends on the exterior lighting position selected, and an indicator light will light up on the instrument panel.

Rear fog lights
Turn centre ring 4 on the stalk until the symbol faces mark 3, then re-lease it. The operation of the fog lights depends on the exterior lighting selected, and an indicator light will light up on the instrument panel.
Do not forget to switch off the fog lights when they are no longer needed, to avoid inconveniencing other road users.

Switching off the lights
Turn the centre ring 4 again until mark 3 is opposite the symbol for the fog lights that you wish to switch off. The corresponding indicator light on the instrument panel goes out. The front and rear fog lights switch off when the exterior lights are switched off.

Cornering lights
(depending on vehicle)
When driving in forward gear, with the vehicle speed below approximately 25 mph (40 km/h), whenever the dipped beam headlights are on: under certain conditions (the steering wheel at an angle, the indicator lights on etc.), when turning a corner one of the front fog lights will switch on to light the inside of the bend.
When reverse gear is engaged and the dipped beam headlights are on the two front fog lights illuminate automatically.

Note: when shifting from reverse gear into forward gear (for example during a parking manoeuvre), the two fog lights are activated until the vehicle exceeds approximately 6 mph (10 km/h).

Horn
Press the steering wheel boss A to ac- tivate the horn.

Headlight flasher
Pull stalk 1 towards you then release it to flash the headlights.

Direction indicators
Move the stalk 1 in the same direction as you want to move the steering wheel.

One-touch mode
When driving, it is possible that the steering wheel may not be turned sufficiently to return the stalk automatically to its starting position.
In this case, move the stick 1 to half- way, then release it: the stalk returns to its original point and the indicator light flashes three times.

é Hazard warning lights
Press switch 2. This switch activates all four direction indicators and the side indicator lights simultaneously. It must only be used in an emergency to warn drivers of other vehicles that you have had to stop in an area where stopping is prohibited or unexpected, or that you are obliged to drive under special conditions.

HEADLIGHT BEAM ADJUSTMENT
Switch A is used to adjust the height of the headlight beams according to the load. With the dipped beam headlights lit, press or lift switch A as many times as is necessary to select the required position on the instrument panel. The position selected is displayed on the instrument panel for approximately 30 seconds.

Note: depending on the vehicle, at each engine start-up the selected po- sition may be displayed on the instru- ment panel for approximately 30 seconds.

WINDSCREEN WASH, WIPE

Operating faults
In the event of a malfunction of the automatic wiping, the wiper is set to intermittent wiping. Contact an authorised dealer.

The operation of the rain sensor can be disturbed in the event of:

• damaged windscreen wipers; a film of water or traces left by a blade in the sensor’s detection zone may increase the response time of the automatic wiper, or in- crease the wiping frequency;
• a windscreen with any chip or crack level with the sensor, or a windscreen covered in dust, dirt, insects, ice, the use of washing wax and water-repellent chemi- cals; the windscreen wiper will be less sensitive or may even not react at all.

Special note
When driving the vehicle, the wiping speed slows down whenever the vehi- cle stops. For example, fast wiping speed will slow to normal wiping speed. As soon as the vehicle moves off, wiping will return to the speed originally selected. If stalk 1 is operated, it overrides and cancels the automatic function.

Precautions

• In the event of ice, check whether the blades are stuck to the windscreen before operating the wiping mecha- nism. If you activate the wipers while the blades are stuck down with ice, you may risk damaging both the blade and the wiper motor.
• Do not activate the wipers on a dry screen. This will lead to premature wear or damage to the blades.

REAR SCREEN WASHER, WIPER

Activation/deactivation of the rear screen wiper
Engaging reverse gear triggers inter- mittent wiping (if the front wipers are in operation). If your vehicle is equipped with a vehicle settings customisation menu, you can opt to activate or deacti- vate this function. For vehicles not fitted with a settings customisation menu, you can have this function deactivated by an authorised dealer. In the event of obstacles present on the rear window (dirt, snow, etc.), the wiper will try to sweep away all the obstacles. If an obstacle prevents the blade from moving, it can be stopped. Remove the obstacle, wait for around 30 seconds and reactivate the wiper using the wiper stalk.

Precautions

• In the event of ice, check that the blades are not stuck to the wind- screen before operating the wipers. If you activate the wiper while the blade is blocked by ice, you risk dam- aging both the blade and the wiping motor.
• Do not operate the wipers on a dry screen. This will lead to the prema- ture wear or damage to the blades.

Rear screen wash/wipe
With the ignition on, push and hold stalk 1, then release. Holding the stalk for longer will trigger (in addition to the windscreen washer) two sweeps of the wipers followed, a few seconds later, by a third (drip wiping function). When the stalk is released, it returns to the rear wipe position.

Useable tank capacity:

• Approximately 9.24 gallons (42 litres) for petrol versions;
• Approximately 8.58 gallons (39 litres) for diesel versions.

With the vehicle unlocked, to open cover 1, press area A then release. The cover 1 opens slightly. Use the cap holder 2 on the flap 1 during filling to hold the cap 3 in place. For details on filling the fuel tank, refer to the information on “Filling up with fuel”. To close it, press on the fuel filler flap by hand, as far as it will go.

Diesel version
It is essential to use diesel fuel that conforms with the information given on the label inside cover 1.

Petrol version
It is essential to use unleaded petrol. The octane rating (RON) must comply with the information given on the label on the cover 1.

Filling with fuel
With the ignition off, insert the nozzle and insert it fully before turning it on to fill the fuel tank (risk of splashing). Keep the nozzle in this position throughout the entire filling operation. When the pump cuts out automatically at the end of the filling procedure, a maximum of two further filling attempts may be made, as there must be suffi- cient space in the fuel tank to allow for expansion. Make sure that no water enters the fuel tank during filling. The cover 1 and its surround must remain clean.

Special case
When the vehicle has been stopped for around three months, you must add fuel to prevent damage to the fuel pump. To do this, with the ignition off, top-up at least 1.10 gallons (5 litres) then start the engine to operate the pump and renew the fuel in the circuit. If it is not possible to add at least 1.10 gallons (5 litres) of fuel due to the fuel level in the tank, drive the vehicle until the tank has capacity.

Petrol versions
Using leaded petrol will damage the antipollution system and may lead to a loss of warranty. To ensure that the tank is not filled with leaded petrol, the fuel tank filler neck consists of a restrictor fitted with a safety system which only allows a nozzle for unleaded petrol to be used (at the pump).

Running out of fuel on diesel versions
Vehicles with key/remote control

• Set the ignition key to “On” position and wait a few minutes before starting to enable the fuel circuit to be primed;
• turn the key to position D. If the engine does not start, repeat the procedure;
• if the engine does not start after several attempts, please contact an authorised dealer.

Vehicles with card
With the card in the passenger compartment, press the start button 4 without pressing any of the pedals. Wait a few minutes before starting.
This will enable the fuel circuit to be primed. If the engine does not start, repeat the procedure. If the engine does not start after several attempts, please contact an authorised dealer.

Filling stations with self service
We recommend that you wear gloves when handling the LPG pistol.
Open the tank flap of your vehicle and unscrew the cap 6 from the end piece of the LPG filler 7. Carefully follow the instructions shown on LPG distributors. These explain how to fill up properly. Depending on the type of station, it may be necessary to perform press and hold the station button before filling will start. When the pump stops supplying LPG, or when the pump flow reduces sig- nificantly, the maximum tank level has been reached. The filling will stop as soon as you re- lease the button. Release the stop lever (a small amount of gas may be re- leased), lift the pistol and place it on the distributor. Replace the cap 6 to avoid any water or foreign bodies from entering the system.

Operating principle
The reagent is intended for diesel engines fitted with the SCR (selective catalytic reduction) system. Using a reagent reduces the quantity of nitrogen oxides in exhaust gases. Reagent consumption in real time depends on vehicle usage conditions, the equipment fitted, and driving style.

Reagent quality
Use only reagents which conform to standard ISO 22241 and in accordance with the mark on the tank filler cap.

Filling 
The tank can be filled at the pump. With the ignition off, insert the nozzle fully before activating it to fill the fuel tank (risk of splashing). Keep the nozzle in this position throughout the entire filling operation.
When the pump cuts out automatically at the end of the filling procedure, a maximum of two further filling attempts may be made, as there must be sufficient space in the fuel tank to allow for expansion.
In other filling cases, it is essential to read the information shown on the reagent container (e.g. the can or bottle).

Precautions for use
When filling:

• handle the reagent with care. They can damage clothes, shoes, bodywork components etc.;
• make sure that no water enters the fuel tank.

If the reagent overflows, or contaminates any paintwork, clean the affected area quickly with plenty of cold water and a soft cloth.

Note: if the reagent crystallises, use a soft sponge.

In extreme cold weather conditions
In frosty weather conditions, the rea- gent tank should be refilled when the indicator and the message “TOP UP AdBlue before 1200 km” appear on the instrument panel.

Special cases
The reagent fluid freezes below about -10°C. In these conditions, do not attempt filling when the fluid is frozen. In the event of needing to top up or fill the tank with reagent ( on), park the vehicle in a hotter location if possible so that the reagent becomes liquid again. Otherwise, have a qualified professional top up or fill up with reagent fluid.

After filling the reagent tank, check that the cap and cover are closed, start the engine and WAIT 10 seconds with the vehicle stationary, engine running before setting off again. If this operation is not carried out, the filling of the tank will not be taken into account automatically until after several dozens of minutes of driving. The message “— Top up AdBlue” and/or the warning lights will continue to appear until the filling has been taken into account by the system.

FAQ

Useful Link

2024 Renault Austral Owner’s Manual
2022 Renault Captur Owner’s Manual