2022 Renault Trafic Owner’s Manual
A mainstay in the light commercial vehicle market, the 2022 Renault Trafic has undergone major upgrades to further enhance its allure for both corporate and private consumers. This model year debuted a redesigned exterior that adheres to the most recent Renault design language, with a more contemporary and robust appearance. To meet the demands of contemporary drivers, the Trafic’s interior was upgraded with updated entertainment systems, better ergonomics, and cutting-edge connections. The car’s engine choices were efficient and had eco-friendly versions to satisfy different environmental and performance standards. In the competitive light commercial van market, the 2022 Trafic was a practical, adaptable, and dependable option thanks to its multitude of safety and driver-assistance technologies.
REAR SCREEN WASHER, WIPER
Y Rear windscreen wiper
With the ignition on, turn the ring 3 on the stalk 1 until the symbol is opposite the 2 mark. To stop operation, turn the ring 3 again to the off position.
Note: when washing using a roller-type car wash, return ring 3 on the stalk 1 to the stop position to deactivate automatic wiping.
Follow usage recommendations. Do not use the wiper arm to open or close the tailgate. Before any action on the windscreen (washing the vehicle, de-icing, cleaning the windscreen, etc.) return stalk 1 to the park position. Risk of injury and/or damage.
Efficiency of a wiper blade
Check the condition of the wiper blades. How long they last depends on you:
- it must remain clean: clean the blade and the screen regularly with soapy water;
- do not use it when the screen is dry;
- free it from the screen when it has not been used for a long time.
In all cases, replace it as soon as it begins to lose efficiency: approximately once a year.
Precautions for using the wipers
- In freezing or snowy weather, clear the screen before starting the wipers (risk of motor overheating);
- ensure that no objects are obstructing the travel of the blade.
Activation/Deactivation of the rear screen wiper
Engaging reverse gear triggers intermittent wiping (if the front wipers are in operation). If your vehicle is equipped with a vehicle settings customisation menu, you can opt to activate or deactivate this function. Refer to the multimedia instructions. For vehicles not fitted with a settings customisation menu, you can have this function deactivated by an authorised dealer. When working in the engine compartment, ensure that the windscreen wiper stalk is in the park position. In the event of obstacles present on the rear window (dirt, snow, etc.), the wiper will try to sweep away all the obstacles.
If an obstacle prevents the blade from moving, it can be stopped. Remove the obstacle, wait for around 30 seconds and reactivate the wiper using the wiper stalk.
Precautions
- If the weather is icy, check that the blade is not stuck to the windscreen before operating the wipers. If you activate the wiper while the blade is blocked by ice, you risk damaging both the blade and the wiping motor.
- Do not operate the wipers on a dry screen. This will lead to premature wear or damage to the blades.
Rear screen wash/wipe
With the ignition on, push and hold stalk 1, then release. Holding for longer will trigger three sweeps of the wipers followed, a few seconds later, by a fourth, in addition to the windscreen washer.
Filling with fuel
With the ignition off, insert the nozzle and insert it fully before turning it on to fill the fuel tank (risk of splashing). Keep the nozzle in this position throughout the entire filling operation. When the pump cuts out automatically at the end of the filling procedure, a maximum of two further filling attempts may be made, as there must be sufficient space in the fuel tank to allow for expansion. Make sure that no water enters the fuel tank during filling. Cover A and its surroundings must remain clean.
Running out of fuel on diesel versions
Vehicles with key/remote control
- Set the ignition key to “On” position and wait a few minutes before starting to enable the fuel circuit to be primed;
- turn the key to position D. If the engine does not start, repeat the procedure;
- if the engine does not start after several attempts, please contact an authorised dealer.
No modifications what-soever are permitted on any part of the fuel supply system (electronic units, wiring, fuel circuit, injectors, protective covers, etc.) as this may be dangerous (unless undertaken by qualified Network personnel). Please note when working close to the engine that it may be hot. In addition, the engine cooling fan may start at any moment. The warning light in the engine compartment reminds you of this.
Filler cap: this is specific.
If you have to replace it, make sure it is identical to the original cap. Contact an approved Dealer. Never place the cap near a source of heat or flame. Do not wash the filler area with a high-pressure washer.
Vehicles with card
With the card in the passenger compartment, press the start button 3 without pressing any of the pedals. Wait a few minutes before starting. This will enable the fuel circuit to be primed. If the engine does not start, repeat the procedure.
Persistent fuel odour
If you notice a persistent fuel odour you should:
- stop the vehicle as soon as traffic conditions allow and switch off the ignition;
- switch on the hazard warning lights and ask your passengers to leave the vehicle and stay clear of the traffic;
- contact an approved Dealer.
REAGENT TANK
Please ensure that you comply with the legislation of your country.
It is important to remember that failure to respect regulations in force could lead to legal action being taken against the vehicle owner.
Operating principle
The reagent is intended for Diesel engines fitted with the SCR (selective catalytic reduction) system. Using the re-agent reduces the quantity of nitrogen oxides in exhaust gases. Consumption in real-time depends on vehicle usage conditions, the equipment fitted and the user’s driving style.
Reagent quality
Use only reagents which conform to standard ISO 22241 and in accordance with the mark on the tank filler cap.
Filling
Useable capacity of the tank: be-tween approximately 4.84 gal and 5.5 gal (22 litres and 25 litres) (de-pending on the vehicle). Ignition off, open the front left door to open the cover A. Unscrew the cap 1.
Note: ammonium hydroxide vapour may escape from the cap opening when the tank temperature is high.
Filler cap: this is specific. If you have to replace it, make sure it is identical to the original cap. Contact an approved Dealer. Do not wash the filler area with a high-pressure washer.
REAGENT TANK
Precautions for use
The tank can be filled at the pump. In other cases, it is essential to read the information shown on the reagent container (e.g. the can or bottle).
When filling, handle the reagent carefully. They can damage clothes, shoes, bodywork components etc. If the reagent overflows, or contaminates any paintwork, clean the affected area quickly with plenty of cold water and a soft cloth.
Note: if the reagent crystallises, use a soft sponge. In extreme cold weather conditions In frosty weather conditions, the rea- gent tank should be refilled when the indicator and the message “TOP UP AdBlue before 1200 km” appear on the instrument panel.
Special cases
The reagent fluid freezes below approximately -10°C. In these conditions, do not attempt filling when the fluid is frozen. In the event of needing to top up or fill the tank with reagent (on), park the vehicle in a hotter location if possible so that the re-agent becomes liquid again. Otherwise, have a qualified professional top up or fill up with reagent fluid. The reagent must not come into contact with eyes or skin. If it does, wash the affected area with plenty of cold water. If necessary, consult a doctor. After filling the reagent tank, check that the cap and cover are closed, start the engine and WAIT 10 seconds with the vehicle stationary, engine running before setting off again.
If this operation is not carried out, the filling of the tank will not be taken into account automatically until after several dozen minutes of driving. The message “— TOP UP AdBlue” and/or the warning lights will continue to appear until the filling has been registered by the system work whatsoever is permitted on any part of the system. To prevent damage, only qualified personnel from our network may work on the system.
Diesel version
For the first 932 miles (1,500 km), do not exceed 80 mph (130 km/h) in the highest gear, or 2,500 rpm. After completing this mileage you may drive faster, although you may only expect top performance after approximately 3,600 miles (6,000 km). During the running in period, do not accelerate hard while the engine is still cold and do not let the engine overrev. Service intervals: refer to the Maintenance Document for your vehicle.
Off position LOCK 0 (steering lock applied)
- To lock: remove the key and turn the steering wheel until the steering column locks.
- To unlock: turn the key and the steering wheel slightly.
“Ignition” position ON 2
The ignition is switched on: Any accessories (radio etc.) can be used.
“Start” position START 3
If the engine fails to start at the first attempt, the key must be turned back before the starter can be activated again. Release the key as soon as the engine starts.
Note: on diesel versions, several seconds may pass between turning the key and the engine starting to allow for engine preheating.
Starting the engine
Turn the ignition key to the “On” position M and hold this position until the engine preheating light goes out.
To start:
on vehicles equipped with automatic gearboxes, set the lever to position P or N.
For all vehicles:
turn the key to the “Start” position D without pressing the accelerator pedal. Release the key as soon as the engine starts.
Starting the vehicle
On flat, level ground, with the vehicle unladen, you are recommended to start in second gear. Never start your vehicle while freewheeling on a gradient. Risk of non-activation of power-assisted steering. There is a risk of accidents. Never switch off the ignition before the vehicle has stopped completely. Once the engine has stopped, the brake servo, power-assisted steering, etc., and the passive safety devices such as the airbags and pre-tensioners will no longer operate.
Stopping the engine
With the engine idling, turn the key back to the “Stop” position St.
Driver’s responsibility when parking or stopping the vehicle
Never leave an animal, child or adult who is not self-sufficient alone in your vehicle, even for a short time. They may pose a risk to themselves or to others by starting the engine, activating equipment such as the electric windows or locking the doors, for example. Also, in hot and/or sunny weather, please remember that the temperature inside the passenger compartment increases very quickly.
RISK OF DEATH OR SERIOUS INJURY.
STARTING, STOPPING THE ENGINE: vehicle with card
The card must be in detection zone 1 for the van version and in detection zone 2 for the combi version. Press the button 3.
To start:
- vehicles with an automatic gearbox, place the lever in position P or N, de-press the brake pedal and press button 3;
- vehicles with a manual gearbox, depress the brake or clutch pedal and press the button 3. If a gear is engaged, the vehicle may only be started by depressing the clutch pedal.
Starting the vehicle
On flat, level ground, with the vehicle unladen, you are recommended to start in second gear.
Special note:
- if one of the starting conditions is not met, the message “Press Brake + START”, “Press Clutch + Start” or “Select Gearbox Position “P”” is displayed on the instrument panel;
- in some cases, it will be necessary to move the steering wheel whilst pressing the start button 3 to help unlock the steering column; the message “Turn Steering Wheel + START” will warn you of this;
- when starting the engine in very low exterior temperatures (below -10°C): hold down the clutch pedal or the brake pedal until the engine starts.
Accessories function (switching on the ignition)
Once you have gained access to your vehicle, you may use some of its functions (radio, navigation, wipers, etc.). To use the other functions, with the card in the passenger compartment, press the 3 buttons without pressing the pedals.
Driver’s responsibility when parking or stopping the vehicle
Never leave an animal, child or adult who is not self-sufficient alone in your vehicle, even for a short time. They may pose a risk to themselves or to others by starting the engine, activating equipment such as the electric windows or locking the doors, for example. Also, in hot and/or sunny weather, please remember that the temperature inside the passenger compartment increases very quickly.
RISK OF DEATH OR SERIOUS INJURY.
Conditions for stopping the engine
The vehicle must be at a standstill. The vehicle must be stationary, with the lever positioned in P or N for vehicles with an automatic gearbox.
The card must be in detection zone 1 on the van version and in detection zone 2 on the combi version. Press button 3: the engine stops. The steering column is locked when the driver’s door is opened or the vehicle is locked. If the card is no longer in the passenger compartment or if the card battery is flat when the vehicle is stationed- ary and you try to switch the engine off, the message
“Keycard absent: press/ hold START” appears on the instrument panel: press the 2 buttons for longer than three seconds. With the engine switched off, any accessories being used (radio etc.) will continue to function for approximately 10 minutes. When the driver’s door is opened, the accessories stop working. Never switch off the ignition before the vehicle has stopped completely. Once the engine has stopped, the brake servo, power-assisted steering, etc., and the passive safety devices such as the airbags and pre-tensioners will no longer operate.
Operating faults
In certain cases, the hands-free card may not work:
- when the card battery is drained, flat battery etc.
- near to appliances operating on the same frequency as the card (monitor, mobile phone, video game, etc.);
- vehicle located in a high electromagnetic radiation zone.
The message “Place card on zone + START” appears on the instrument panel. Press the brake or clutch pedal, then place card 5 (button side facing you) at the angle indicated on one of the placement areas 4. Press the 3 button to start the vehicle. The message goes out. When you leave your vehicle, especially if you have your card with you, check that the engine is completely switched off.
Driver’s responsibility when parking or stopping the vehicle
Never leave an animal, child or adult who is not self-sufficient alone in your vehicle, even for a short time. They may pose a risk to themselves or to others by starting the engine, activating equipment such as the electric windows or locking the doors, for example. Also, in hot and/or sunny weather, please remember that the temperature inside the passenger compartment increases very quickly.
RISK OF DEATH OR SERIOUS INJURY.
FAQ
The 2022 Renault Trafic is a light commercial van.
The 2022 model features a refreshed exterior design, an updated cabin with improved ergonomics, advanced connectivity, and updated infotainment systems.
It offers a range of efficient engines, including eco-friendly options.
Yes, the 2022 Trafic has an enhanced cabin with a focus on comfort and functionality.
It comes equipped with various safety and driver-assistance features, including advanced airbags, stability control, and optional technologies like lane departure warning.
With its comfortable interior and efficient engines, it is well-suited for long distances.
Yes, it offers various customization options to cater to different commercial requirements.
The payload capacity varies based on the model and configuration but is generally competitive within its class.
Yes, it includes modern infotainment options, though specifics depend on the trim and options selected.
It is competitive in terms of space, efficiency, and features, often compared favourably to its rivals in the light commercial van segment.
Warranty periods vary by region, so it’s best to check with a local Renault dealer.
Renault has offered electric versions of the Trafic in the past, but availability depends on the market.
Its design and engine options make it suitable for urban use, offering good manoeuvrability and efficiency.
Seating options vary based on the configuration, with options suitable for both passenger and commercial use.
Yes, there are configurations available that are suitable for passenger transport.