2024 Toyota Camry

The 2024 Toyota Camry, one of the most well-liked midsize sedans in history will take a big stride ahead. With its newest model, Toyota hopes to combine contemporary technology innovations with its longstanding dedication to dependability and efficiency. The 2024 Camry endeavours to provide a harmonious blend of efficiency, comfort, and environmental friendliness through the introduction of improved safety features, upgraded hybrid powertrain options, and an upgraded interior. Its aerodynamic and sleeker style is expected to increase its appeal to a broad spectrum of buyers looking for a durable yet fashionable car.

Instrument panel light control

The brightness of the instrument panel lights can be adjusted.

1. Darker
2. Brighter
   • The brightness of the instrument panel lights can be adjusted individually for day mode and night mode*.
   • If the brightness is adjusted when the surroundings are bright and the tail lights are on (day mode brightness adjustment), the brightness level of night mode will be adjusted at the same time.
   • The meters and display illuminate when
     • Vehicles without a smart key system
       The engine switch is in the “ON” position.
     • Vehicles with a smart key system
       The engine switch is in IGNITION ON mode.
   • Brightness of the meters (day mode and night mode)
     • The brightness of the meters is changed between day mode and night mode.
       1. Day mode: When the tail lights are off or when the tail lights are on but the surrounding area is bright
       2. Night mode: When the tail lights are on and the surrounding area is dark
     • When in night mode, the brightness will be reduced slightly unless the meters are set to the maximum brightness level.
        
   • Outside temperature display
     In the following situations, the correct outside temperature may not be displayed, or the display may take longer than normal to change:
     • When stopped, or driving at low speeds (less than 16 mph [25 km/h])
     • When the outside temperature has changed suddenly (at the entrance/exit of a garage, tunnel, etc.)
   • Take your vehicle to your Toyota dealer.
   • Fuel gauge and driving range display
     The fuel gauge and driving range display are linked. If the fuel gauge and driving range display do not update after refueling a small amount, they can be updated by performing the following procedure:
     • Stop the vehicle on a level surface. Wait until the fuel in the fuel tank stabilizes.
     • Press the ODO/TRIP switch to change the odometer and trip meter display to the odometer.
     • Turn the engine switch off.
     • Vehicles without a smart key system:
     • While pressing and holding the ODO/TRIP switch, turn the engine switch to the “ON” position.
     • Vehicles with a smart key system:
     • While pressing and holding the ODO/TRIP switch, turn the engine switch to IGNITION ON mode.
     • Continue holding the ODO/TRIP switch for approximately 5 seconds. Release the switch when the odometer begins blinking.
     • Updating will be complete when the odometer blinks for approximately 5 seconds and then returns to the normal display.

NOTICE

• To prevent damage to the engine and its components
  • Do not let the indicator needle of the tachometer enter the red zone, which indicates the maximum engine speed.
  • The engine may be overheating if the engine coolant temperature gauge is in the red zone (H). In this case, immediately stop the vehicle in a safe place, and check the engine after it has cooled completely.

Summary of functions
The multi-information display presents the driver with a variety of driving-related data, such as the current outside temperature. The multi-information display can also be used to change the display settings and other settings.

Using the multi-information display

Using the content display area
The content display area is operated using the meter control switches.

1. Scroll screens*, change the displayed content* and move the cursor
2. Press: Enter/Set
3. Press and hold: Reset
4. Return to the previous screen
5. Pressing and holding the switch will display the first screen of the selected menu icon.
6. Call sending/receiving and history display Linked with the hands-free system, sending or receiving call is displayed. For details regarding the hands-free system, refer to “NAVIGATION AND MULTIMEDIA SYSTEM OWNER’S MANUAL”.

Using the odometer/trip meter
Items in this area are operated using the “ODO/TRIP” switch.

• Press: Change displayed item Each time the switch is pressed, the displayed item will be changed.
• Press and hold: Reset Display the desired trip meter and press and hold the switch to reset the trip meter.

Drive information

• Trip (after start)
  1. Average fuel economy*
     Displays the average fuel con-sumption since engine start.
  2. Average vehicle speed
     Displays the average vehicle speed since engine start.
  3. Elapsed time
     Displays the time elapsed since engine start.
• Total (after reset)
  1. Current fuel consumption
     Displays the instantaneous current fuel consumption.
  2. Average fuel economy*1, 2
     Displays the average fuel consumption since the display was reset.
  3. Average vehicle speed/Elapsed time
     Displays the average vehicle speed since reset or elapsed time since reset, as selected in.
     1. Pressing and holding will reset the average fuel consumption and average vehicle speed/elapsed time.
     2. Use the displayed fuel consumption as a reference only.
• Tank (after refuelling).
  • Driving range*1, 2
  • Displays the driving range with the remaining fuel. Average fuel economy*1, 3
  • Displays the average fuel con-sumption since the vehicle was refuelled.
    • When only a small amount of fuel is added to the tank, the display may not be updated. When refuelling, turn the engine switch off. If the vehicle is refuelled without turning the engine switch off, the display may not be updated.
    • This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.
    • Use the displayed fuel consumption as a reference only.
• Eco Driving Indicator
  • Speedometer
    Displays the vehicle speed.
  • Tire pressure (vehicles with a tire inflation pressure display function)
  • Blank (No items)
    Displays no drive information contents.

Odometer/trip meter

• Odometer
  Displays the total distance the vehicle has been driven.
• Trip meter A/trip meter B
  Displays the distance the vehicle has been driven since the meter was last reset. Trip meters A and B can be used to record and dis-play different distances independently. To reset, display the desired trip meter and press and hold the “ODO/TRIP” switch.

Suggestion function
Displays suggestions to the driver in the following situations. To select a response to a displayed suggestion, use the meter control switches.

• Suggestion to turn off the headlights
  If the headlights are left on for a certain amount of time after the engine switch has been turned off, if the headlight switch is in the “AUTO” position, a suggestion message will be displayed asking if you wish to turn the headlights off. To turn the headlights off, select “Yes”. If a front door is opened after the engine switch is turned off, this sug-gestion message will not be displayed.
• Eco Driving Indicator

1. Eco Driving Indicator Light
   During Eco-friendly acceleration (Eco-driving), the Eco Driving Indicator Light will turn on. When the acceleration exceeds the Zone of Eco driving, or when the vehicle is stopped, the light turns off.
2. Eco Driving Indicator Zone Display
   Suggests the Zone of Eco-driving with the current Eco-driving ratio based on acceleration.
3. Eco-driving ratio based on acceleration
   If the acceleration exceeds the Zone of Eco driving, the right side of the Eco Driving Indicator Zone Display will illu-minate.
4. Zone of eco-driving
   Eco Driving Indicator will not operate under the following conditions:
   • The shift lever is in any position other than D.
   • A paddle shift switch (if equipped) is operated.
   • The vehicle speed is approximately 80 mph (130 km/h) or higher.

• Suspension of the settings display
  • Some settings cannot be changed while driving. When changing settings, park the vehicle in a safe place.
  • If a warning message is displayed, the operation of the settings display will be suspended.
• Tire pressure (vehicles with a tire inflation pressure display function)
  • It may take a few minutes to display the tire inflation pressure after the engine switch is turned to the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system). It may also take a few minutes to display the tire inflation pressure after the inflation pressure has been adjusted.
  • “—” may be displayed if the tire position information cannot be determined due to unfavourable radio wave conditions.
  • Tire inflation pressure changes with temperature. The displayed values may also be different from the values measured using a tire pressure gauge.
• Liquid crystal display
  Small spots or light spots may appear on the display. This phenomenon is characteristic of liquid crystal displays, and there is no problem continuing to use the display.
• Customization
  Some functions can be customized.

WARNING

• Caution for use while driving
  • When operating the multi-information display while driving, pay extra attention to the safety of the area around the vehicle.
  • Do not look continuously at the multi-information display while driving as you may fail to see pedestrians, objects on the road, etc. ahead of the vehicle.
• The information displayed at low temperatures
  Allow the interior of the vehicle to warm up before using the liquid crystal information display. At extremely low temperatures, the information display monitor may respond slowly, and display changes may be delayed. For example, there is a lag between the driver’s shifting and the new gear number appearing on the display. This lag could cause the driver to down-shift again, causing rapid and excessive engine braking and possibly an accident resulting in death or injury.
• Cautions during setting up the display
  As the engine needs to be running while setting up the display, ensure that the vehicle is parked in a place with adequate ventilation. In a closed area such as a garage, exhaust gases including harmful carbon monoxide (CO) may collect and enter the vehicle. This may lead to death or a serious health hazard.

NOTICE

• While setting up the display
  To prevent battery discharge, ensure that the engine is running while setting up the display features.

Summary of functions
The multi-information display presents the driver with a variety of driving-related data, such as the current outside temperature. The multi-information display can also be used to change the display settings and other settings.

1. Indicators 
   The driving assist system status display area Displays the operational status of the following systems:
   • Dynamic radar cruise control with full-speed range (if equipped)
   • Dynamic radar cruise control (if equipped)
   • LTA (Lane Tracing Assist)
2. Speed limit display (vehicles with a navigation system)
   (U.S.A. only) /RSA (Road Sign Assist) (if equipped)
3. Clock
   For clock settings, refer to “NAVIGATION AND MULTIMEDIA SYSTEM OWNER’S MANUAL”.
4. RSA (Road Sign Assist) (if equipped)
5. Speedometer
   The speedometer display can be enabled/disabled in on the multi-information display.
6. Content display area
   A variety of information can be displayed by selecting a menu icon. Additionally, warning or suggestion/advice pop-up displays will be displayed in some situations.
   • Menu icon content
   • Suggestion function
   • Warning message
7. Odometer/trip meter
8. Shift position
9. Outside temperature
10. Menu icons
11. “ODO/TRIP” switch
12. Meter control switches

Using the content display area
The content display area is operated using the meter control switches.

1. Scroll screens*, change the displayed content* and move the cursor
2. Press: Enter/Set
   Press and hold: Reset/Display the next screen
3. Return to the previous screen
   Pressing and holding the switch will display the first screen of the selected menu icon.
4. Call sending/receiving and history display
   Linked with the hands-free system, sending or receiving calls is displayed. For details regarding the hands-free system, refer to “NAVIGATION AND MULTIMEDIA SYSTEM OWNER’S MANUAL”.

Using the odometer/trip meter
Items in this area are operated using the “ODO/TRIP” switch.

• Press: Change displayed item
  Each time the switch is pressed, the displayed item will be changed.
• Press and hold: Reset
  Display the desired trip meter and press and hold the switch to reset the trip meter.

Fuel consumption

1. Current fuel consumption
   Displays the instantaneous current fuel consumption.
2. Average fuel economy (after start)
   Displays the average fuel consumption since engine start.
3. Driving range
   Displays the driving range with the remaining fuel.
4. Gadget*4
5. The following items can be displayed by changing the settings for gadget content and fuel economy type.
6. Average fuel economy
   Displayed items (listed below) can be changed on the fuel economy type screen.
   • Total (after reset)
     Displays the average fuel consumption since the display was reset.*1, 5
   • Tank (after refuel)
     Displays the average fuel consumption since the vehicle was refuelled.*
     • Use the displayed fuel consumption as a reference only.
     • When only a small amount of fuel is added to the tank, the display may not be updated. When refuelling, turn the engine switch off. If the vehicle is refueled without turning the engine switch off, the display may not be updated.
     • This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.
     • The default setting is no display.
     • This display can be reset by pressing and holding while it is displayed.

• Eco indicator
  • Eco Driving Indicator
  • Driving range
    Displays the driving range with the remaining fuel. When only a small amount of fuel is added to the tank, the display may not be updated. When refuelling, turn the engine switch off. If the vehicle is refuelled without turning the engine switch off, the display may not be updated. This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.
• Speedometer display/Driving range
  1. Speedometer display
     Displays the vehicle speed.
  2. Driving range
     Displays the driving range with the remaining fuel. When only a small amount of fuel is added to the tank, the display may not be updated. When refuelling, turn the engine switch off. If the vehicle is refuelled without turning the engine switch off, the display may not be updated.

This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.

FAQ

Useful Link

2018 Toyota 4Runner Owner’s Manual

2021 Toyota Sienna Hybrid Owner’s Manual