2024 Toyota Tundra Seat Belts Owner’s Manual
Innovative seat belts with cutting-edge tensioning technology are available on the 2024 Toyota Tundra, assuring increased passenger safety. With their adjustable features and snug fit, these seat belts offer comfort and security for every travel. Toyota focuses on safety in the new Tundra’s seat belt design without sacrificing comfort thanks to state-of-the-art innovation.
2023 – 2024 Toyota Tundra Review Specs, Price And Mileage (Brochure)
Toyota Seat belts Guide
Make sure that all occupants are wearing their seat belts before driving the vehicle.
WARNING
Observe the following precautions to reduce the risk of injury in the event of sudden braking, sudden swerving or an accident. Failure to do so may cause death or serious injury.
Wearing a seat belt
- Ensure that all passengers wear a seat belt.
- Always wear a seat belt properly.
- Each seat belt should be used by one person only. Do not use a seat belt for more than one person at once, including children.
- Toyota recommends that children be seated in the rear seat and always use a seat belt and/or an appropriate child restraint system.
- To achieve a proper seating position, do not recline the seat more than necessary. The seat belt is most effective when the occupants are sitting up straight and well back in the seats.
- Do not wear the shoulder belt under your arm.
- Always wear your seat belt low and snug across your hips.
Pregnant women
Obtain medical advice and properly wear a seat belt.
Women who are pregnant should position the lap belt as low as possible over the hips in the same manner as other occupants, extending the shoulder belt completely over the shoulder and avoiding belt contact with the rounding of the abdominal area.
If the seat belt is not worn properly, not only the pregnant woman but also the fetus could suffer death or serious injury as a result of sudden braking or a collision.
People suffering illness
Obtain medical advice and properly wear a seat belt.
When children are in the vehicle
Seat belt damage and wear
- Do not damage the seat belts by allowing the belt, plate, or buckle to be jammed in the door.
WARNING
- Inspect the seat belt system periodically. Check for cuts, fraying, and lose parts. Do not use a damaged seat belt until it is replaced. Damaged seat belts cannot protect an occupant from death or serious injury.
- Ensure that the belt and plate are locked and the belt is not twisted.
If the seat belt does not function correctly, immediately contact your Toyota dealer. - Replace the seat assembly, including the belts, if your vehi-cle has been involved in a serious accident, even if there is no obvious damage.
- Do not attempt to install, remove, modify, disassemble or dispose of the seat belts. Have any necessary repairs carried out by your Toyota dealer? Inappropriate handling may lead to incorrect operation.
Correct use of the seat belts
- Extend the shoulder belt so that it comes fully over the shoulder, but does not come into contact with the neck or slide off the shoulder.
- Position the lap belt as low as possible over the hips.
- Adjust the position of the seatback. Sit up straight and well back in the seat.
- Do not twist the seat belt.
Child seat belt usage
The seat belts of your vehicle were principally designed for persons of adult size.
- Use a child restraint system appropriate for the child, until the child becomes large enough to properly wear the vehicle’s seat belt.
- When the child becomes large enough to properly wear the vehicle’s seat belt, follow the instructions regarding seat belt usage.
Seat belt extender
If your seat belts cannot be fastened securely because they are not long enough, a personalized seat belt extender is available from your Toyota dealer free of charge.
WARNING
Using a seat belt extender
Observe the following precautions to reduce the risk of injury in the event of sudden braking, sudden swerving or an accident. Failure to do so may cause death or serious injury.
WARNING
- Do not wear the seat belt extender if you can fasten the seat belt without the extender.
- Do not use the seat belt extender when installing a child restraint system because the belt will not securely hold the child restraint system, increasing the risk of death or serious injury in the event of an acci-dent.
- The personalized extender may not be safe on another vehicle when used by another person, or at a different seating position other than the one originally intended.
NOTICE
When using a seat belt extender
When releasing the seat belt, press the buckle release button on the extender, not on the seat belt.
This helps prevent damage to the vehicle interior and the extender itself.
Fastening and releasing the seat belt (except for the rear centre seat)
- To fasten the seat belt, push the plate into the buckle until a click sound is heard.
- To release the seat belt, press the release button If the seat belt cannot be pulled out of the retractor, firmly pull the belt and release it.
Emergency locking retractor (ELR)
The retractor will lock the belt during a sudden stop or on impact. It may also lock if you lean forward too quickly. A slow, easy motion will allow the belt to extend so that you can move around fully.
Automatic locking retractor (ALR)
When a passenger’s shoulder belt is completely extended and then retracted even slightly, the belt is locked in that position and cannot be extended. This feature is used to hold the child restraint system (CRS) firmly. To free the belt again, fully retract the belt and then pull the belt out once more.
After using the seat belts on the outboard rear seats
Stow the seat belt buckle in the pockets.
Fastening the seat belt (for the rear centre seat)
- Take out the plate.
- Plate A
- Plate B
- When fixing the belt, in the order of plate A and then plate B, insert the plate into the buckle until a clicking sound is heard.
- Plate A
- Plate B
- Buckle
WARNING
When using the rear centre seat belt
Do not use the rear centre seat belt with either buckle released. Fastening only one of the buckles may result in death or serious injury in case of sudden braking or a collision.
Releasing and stowing the seat belt (for the rear centre seat)
- To release the hooked buckle, push the buckle release button.
- Insert the mechanical key or plate B into the notch of the buckle and remove the belt.
Retract the belt slowly when releasing and stowing the seat belt.
- Mechanical key
- Plate B
- Buckle
- Stow in the holder in the order of plate B and then plate A.
To securely fix it, firmly insert it into the back.
- Plate A
- Plate B
- Stow the seat belt buckle in the pocket.
Emergency locking retractor (ELR)
The retractor will lock the belt during a sudden stop or on impact. It may also lock if you lean forward too quickly. A slow, easy motion will allow the belt to extend so that you can move around fully.
Automatic locking retractor (ALR)
When a passenger’s shoulder belt is completely extended and then retracted even slightly, the belt is locked in that position and cannot be extended. This feature is used to hold the child restraint system
(CRS) firmly. To free the belt again, fully retract the belt and then pull the belt out once more.
2023 – 2024 Toyota Tundra Review Specs, Price And Mileage (Brochure)
Adjusting the seat belt shoulder anchor height (front seats)
- Push the seat belt shoulder anchor down while pressing the release button.
- Push the seat belt shoulder anchor up while pressing the release button
Move the height adjuster up and down as needed until you hear a click.
WARNING
Adjustable shoulder anchor
Always make sure the shoulder belt is positioned across the centre of your shoulder. The belt should be kept away from your neck, but not falling off your shoulder. Failure to do so could reduce the amount of protection in an accident and cause death or serious injuries in the event of a sudden stop, sudden swerve or accident.
Seat belt pretensioners (front and outboard rear seats)
The pretensioners help the seat belts to quickly restrain the occupants by retracting the seat belts when the vehicle is subjected to certain types of severe frontal or side collision or a vehi-cle rollover.
The pretensioners do not activate in the event of a minor frontal impact, a minor side impact or a rear impact.
Replacing the belt after the pre-tensioner has been activated
If the vehicle is involved in multiple collisions, the pretensioner will activate for the first collision, but will not activate for the second or subsequent collisions.
PCS-linked seat belt pretend-sooner control (vehicles with Toyota Safety Sense 2.5)
If the PCS (Pre-Collision System) determines that the possibility of a collision with a vehicle is high, the seat belt pretensioners will be prepared to operate.
WARNING
Seat belt pretensioners
Observe the following precautions to reduce the risk of injury in the event of sudden braking, sudden swerving or an accident. Failure to do so may cause death or serious injury.
- Do not place anything, such as a cushion, on the front passenger’s seat. Doing so will disperse the passenger’s weight, which prevents the sen-sor from detecting the passenger’s weight properly. As a result, the seat belt pretensioner for the front passenger’s seat may not activate in the event of a collision.
WARNING
If the pretensioner has acti-vated, the SRS warning light will come on. In that case, the seat belt cannot be used again and must be replaced at your Toyota dealer.
FAQs
The seat belts in the 2024 Toyota Tundra are equipped with pre-tensioners and force limiters for enhanced safety.
The 2024 Toyota Tundra comes with seat belts for all seating positions, accommodating up to five passengers.
Yes, the seat belts in the 2024 Toyota Tundra are adjustable to ensure a comfortable fit for passengers of various sizes.
The 2024 Toyota Tundra is equipped with seat belt reminders for both the driver and passengers to promote safe driving habits.
Yes, the rear seats in the 2024 Toyota Tundra are equipped with seat belts to provide safety for passengers in the back.
The seat belts in the 2024 Toyota Tundra are designed to accommodate child seats, ensuring the safety of younger passengers.
The seat belts in the 2024 Toyota Tundra are not designed to be removed and should always remain in place for safety reasons.
The seat belts in the 2024 Toyota Tundra are typically made of durable materials such as nylon or polyester.
Yes, the seat belts in the 2024 Toyota Tundra are equipped with pretensioners, which automatically tighten in the event of a collision to reduce slack.
Yes, the seat belts in the 2024 Toyota Tundra are typically covered by the vehicle’s warranty for a certain period.
Some models of the 2024 Toyota Tundra may come with seat belt height adjusters to accommodate passengers of different heights.
It’s recommended to consult with a qualified technician to ensure that any aftermarket accessories are compatible with the seat belts in the 2024 Toyota Tundra.
Yes, the seat belts in the 2024 Toyota Tundra are equipped with emergency locking retractors to secure occupants during sudden stops or impacts.
In the event of damage to the seat belts in the 2024 Toyota Tundra, it’s recommended to have them inspected and repaired by a certified technician for safety.
Typically, seat belt pretensioners are installed in all seating positions of the 2024 Toyota Tundra to enhance occupant safety in the event of a collision.
Yes, the 2024 Toyota Tundra is equipped with seat belt warning lights to remind occupants to buckle up for safety.
Useful Links
View Full PDF: 2024 Toyota Tundra Owners Manual | Auto User Guide
2023 – 2024 Toyota Tundra Review Specs, Price And Mileage (Brochure)